RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   YS Engines Support (https://www.rcuniverse.com/forum/ys-engines-support-197/)
-   -   140DZ Inverted Problem (https://www.rcuniverse.com/forum/ys-engines-support-197/1827879-140dz-inverted-problem.html)

PlaneCrazzy 05-19-2004 07:26 AM

140DZ Inverted Problem
 
My 140DZ 18x8 Mejzlik turning 8500 rpm on 30% CoolMaster. Great power great idle. When I fly inverted the engine sputters like its not getting fuel when I roll back over she runs fine. I have a Tetra bladder tank installed set back about 10" on the CG. ????????????

Dave Shadel 05-19-2004 01:17 PM

RE: 140DZ Inverted Problem
 
It can only be a problem with the tank. Are you sure it is plumbed right?

PlaneCrazzy 05-19-2004 02:23 PM

RE: 140DZ Inverted Problem
 
Dave,
This was the first bladder tank I have installed. I must say that it sucks out every ounce of fuel. It has two lines a vent line and the fuel feed. I cut a tee into the feed to fill with a fuel dot. I have the vent line plugged all the time only remove it to fuel up and when fuel comes out I plug it to fly. On the side of the tank is a vent or spill line if the bladder breaks ? Not sure here which is plumbed out and down that is not plugged.

Chris

Dave Shadel 05-19-2004 02:59 PM

RE: 140DZ Inverted Problem
 
Where is the end of the pickup line in the bladder? Is it stiff or flexible?
Have you flipped the airplane over and observed the fuel line into the pump for bubbles. If it bubbles inverted, you either have a leak in the line or the bladder.

PlaneCrazzy 05-20-2004 06:25 AM

RE: 140DZ Inverted Problem
 
The line into the tank is flexible. I will check for leaks and let you know

Thanks

Chris

Dave Shadel 05-20-2004 10:20 AM

RE: 140DZ Inverted Problem
 
BUT WHERE DOES THE PICKUP LINE STOP IN THE TANK? It should be halfway back.


All times are GMT -8. The time now is 03:01 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.