SD-10G Issue With TX Battery Voltage
#1
Thread Starter
My Feedback: (56)
SD-10G Issue With TX Battery Voltage
The LCD Display overview on my radio shows a fluctuating voltage read. Never happened in the past as far as I recall. Specifically, after a proper fresh charge, the LCD display reads 8.1v and a second later, reads 7.2 v and then it bounces up to 8.1v or 7.6v or 7.4v. After two -three flights, it dips lower which is to be expected, but fluctuates as before to levels I'm uncomfortable with.
Then I stop flying.
At first, I thought it was the original battery, so I changed it to a low time 6 cell 2000mAh Eneloop .
Same voltage irregularities.
The radio went back to Airtronics late last year for the recall/upgrade of the circuit board.
Then I stop flying.
At first, I thought it was the original battery, so I changed it to a low time 6 cell 2000mAh Eneloop .
Same voltage irregularities.
The radio went back to Airtronics late last year for the recall/upgrade of the circuit board.
#2
My Feedback: (29)
Join Date: Nov 2002
Location: Saddle Brook, NJ
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
RE: SD-10G Issue With TX Battery Voltage
I had the same problem after RF upgrade. Removed pack & tested with a load on it & battery made a big drop. It had a bad cell. Replaced with a 2000mah Eneloop NMH & it's ROCK STEADY.