HK Mi Coreless HV 320oz
#1
Senior Member
Thread Starter
Join Date: Jan 2005
Location: CALGARY,
AB, CANADA
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
HK Mi Coreless HV 320oz
http://youtu.be/qHj-i3q44mA
Cheap $30 HK Magnetic Induction Coreless motor, HV Titanium gears. 320oz
Centering test on 2s Lipo.
Speed .16
Trim steps moved every second or third click....so not great.
Centering was not great , but not bad for a $30 servo.
Mi was noisy always hunting for center and slower around center than the Brushless servo tested earlier.
Next will test a Mi Brushless HV, and see what happens
Your feed back is welcome.............
Cheap $30 HK Magnetic Induction Coreless motor, HV Titanium gears. 320oz
Centering test on 2s Lipo.
Speed .16
Trim steps moved every second or third click....so not great.
Centering was not great , but not bad for a $30 servo.
Mi was noisy always hunting for center and slower around center than the Brushless servo tested earlier.
Next will test a Mi Brushless HV, and see what happens
Your feed back is welcome.............
#3
My Feedback: (41)
RE: HK Mi Coreless HV 320oz
http://www.youtube.com/watch?v=hpezYA39CZ8
Here's another one I tested. It's digital coreless low profile
Turngy 1251TG
If you llok on my page I tested a few mor servos. The steps on the trim are not that finite.
The JR servos test a lot better.
Mike
Here's another one I tested. It's digital coreless low profile
Turngy 1251TG
If you llok on my page I tested a few mor servos. The steps on the trim are not that finite.
The JR servos test a lot better.
Mike