Timing of motors
#1
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Haarlem, AK, NETHERLANDS
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
Timing of motors
Is there somebody who can explain the influence of the timing of the controller in relation to the behaviour of the motor.
The reason why I ask is that I received from Hacker to set the controller to 30degrees of timimg to run a Plettenberg 30-10.
I most post, I see 18 degrees, and it the spreadsheet of an other post, I see 5 and 10 degrees.
I read somewhere that there is also a relation with the number of poles the motor has.
In the 'brushed days' you could retime to get higher RPM with higher current.
Thanks
Winfried
The reason why I ask is that I received from Hacker to set the controller to 30degrees of timimg to run a Plettenberg 30-10.
I most post, I see 18 degrees, and it the spreadsheet of an other post, I see 5 and 10 degrees.
I read somewhere that there is also a relation with the number of poles the motor has.
In the 'brushed days' you could retime to get higher RPM with higher current.
Thanks
Winfried