Need help conencting Control Board to PC
#1
Junior Member
Thread Starter
Join Date: Apr 2008
Location: Miami, FL
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Need help conencting Control Board to PC
Hi everyone, I'm new to RC, great I found this forum.
Got my first heli about a week ago, an Eagle 50H03, crashed it about 15 minutes into looking it over from my dining table ...so I thought I'd start out with the simulation software this time around
In addition to the control board that comes with the Eagle 50, I also purchased the Esky Simulator FMS with the control (0905A) (from XHeli.com ...by the way, great guys to do business with -in my experience) ...I really have not gotten any of the controllers to be recognized by the sim software What I'd really like seeing is getting the controller from the Eagle copter to work, this way it'll match the actual copter controls, but even getting the software to recognize the Esky controler would be a huge leap.
The Eagle 50 came with an RS232 cable, so I purchased the card, installed drivers, etc. Installed FMS, but can't any of the Controls to work (except for keyboard) I have listed:
Parallel/Serial IRQ interface 32 bit vxd, Parallel/Serial IRQ interface 16 bit dll and Serial PIC interface (I take it this last one is the new RS232 card?) Anyways none work ...even the Esky control board does not work
I'm sure I'm not the only one with this problem, is there a walk-through thread that you can recommend to get the software to recognize my drivers/control board?
Thanks and really appreciate any help with this.
Got my first heli about a week ago, an Eagle 50H03, crashed it about 15 minutes into looking it over from my dining table ...so I thought I'd start out with the simulation software this time around
In addition to the control board that comes with the Eagle 50, I also purchased the Esky Simulator FMS with the control (0905A) (from XHeli.com ...by the way, great guys to do business with -in my experience) ...I really have not gotten any of the controllers to be recognized by the sim software What I'd really like seeing is getting the controller from the Eagle copter to work, this way it'll match the actual copter controls, but even getting the software to recognize the Esky controler would be a huge leap.
The Eagle 50 came with an RS232 cable, so I purchased the card, installed drivers, etc. Installed FMS, but can't any of the Controls to work (except for keyboard) I have listed:
Parallel/Serial IRQ interface 32 bit vxd, Parallel/Serial IRQ interface 16 bit dll and Serial PIC interface (I take it this last one is the new RS232 card?) Anyways none work ...even the Esky control board does not work
I'm sure I'm not the only one with this problem, is there a walk-through thread that you can recommend to get the software to recognize my drivers/control board?
Thanks and really appreciate any help with this.
#2
RE: Need help conencting Control Board to PC
Have you visist there online forum http://www.rcdiscuss.com? in their forum you will find instruction on how to setup the Esky Simulator FMS with the control (0905A)
Andy
Andy