Volcano SV - Default Factory Settings
05-21-2009, 10:04 PM
#2
Senior Member
Join Date: Dec 2007
Location: Mesa,
AZ
Posts: 1,784
Likes: 0
Received 0 Likes
on
0 Posts
RE: Volcano SV - Default Factory Settings
The high speed is the tall one in the gold sleeve, turn that in all the way, just till snug not tight or you'll break it. Then the low speed needle is on the side of the carb, the side that rotates (opens). Set that at flush with the collar, then the idle screw is right in front of the carb. Make sure you have about a 1mm opening in the carb. Those are base settings, if you ever get outa wack or something go back to those settings and tune from there. Do you know how to tune?
05-21-2009, 10:38 PM
#3
Senior Member
Join Date: Jan 2008
Location: Perham,
MN
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: Volcano SV - Default Factory Settings
ORIGINAL: chevyderek72
The high speed is the tall one in the gold sleeve, turn that in all the way, just till snug not tight or you'll break it. Then the low speed needle is on the side of the carb, the side that rotates (opens). Set that at flush with the collar, then the idle screw is right in front of the carb. Make sure you have about a 1mm opening in the carb. Those are base settings, if you ever get outa wack or something go back to those settings andtune from there. Do you know how to tune?
The high speed is the tall one in the gold sleeve, turn that in all the way, just till snug not tight or you'll break it. Then the low speed needle is on the side of the carb, the side that rotates (opens). Set that at flush with the collar, then the idle screw is right in front of the carb. Make sure you have about a 1mm opening in the carb. Those are base settings, if you ever get outa wack or something go back to those settings andtune from there. Do you know how to tune?
i know thats what u ment to say chevy
