x3810 ADT Mode change
#1
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Maryborough Queensland, AUSTRALIA
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
x3810 ADT Mode change
Hi Danny, or anyone who can help.
I wish to convert my recently aquired 3810 ADT from mode 1 to mode 3 and need to know where in australia i can get this mod done.I am of the belief this mod is possible along with switch and name plate/sticker change and by strapping of the cpu and reset performed.I did contact a JR agent and it was suggested i could swap the aileron and rudder wiring on gimbal pots and trim boards,although i would prefer a more professional approach so as to have screen display the correct information and mixes/functions not be a nightmare to program and use.Any help would be appreciated.
I wish to convert my recently aquired 3810 ADT from mode 1 to mode 3 and need to know where in australia i can get this mod done.I am of the belief this mod is possible along with switch and name plate/sticker change and by strapping of the cpu and reset performed.I did contact a JR agent and it was suggested i could swap the aileron and rudder wiring on gimbal pots and trim boards,although i would prefer a more professional approach so as to have screen display the correct information and mixes/functions not be a nightmare to program and use.Any help would be appreciated.
#3
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Maryborough Queensland, AUSTRALIA
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
RE: x3810 ADT Mode change
Hi Danny,
Tried o'reilly initially,was not much help.
Have since received help elsewhere.
Thanks for your response/reply.
Tried o'reilly initially,was not much help.
Have since received help elsewhere.
Thanks for your response/reply.