BTE Venture 60
#176
Join Date: Apr 2010
Location: Clinton,
IL
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
RE: BTE Venture 60
Very nice wood supplied, and the instruction manual is very good also. You don't need to build over the plans.Justuse a straightline for the leading edge of the wings and space the ribs correctly to make sure both wing halves are equal length. The traling edge sheetingfits right into the slot cut in the ribs Everything fits fine.Any problems, just give Bruce a call. What a nice guy.
Joe
Joe
#178
My Feedback: (1)
RE: BTE Venture 60
ORIGINAL: maynardrupp
When is Bruce going to start selling Venture kits again???
When is Bruce going to start selling Venture kits again???
#180
Senior Member
Join Date: May 2006
Location: Rose Hill,
KS
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
RE: BTE Venture 60
Flew mine this evening for the first time, flew as I expected- Very well!!! Silk and dope with a Saito 70. Looking forward to getting used to the airplane and starting to set it up like I like them.
L.
L.
#181
Senior Member
RE: BTE Venture 60
ORIGINAL: Cherokee Flyer
Flew mine this evening for the first time, flew as I expected- Very well!!! Silk and dope with a Saito 70. Looking forward to getting used to the airplane and starting to set it up like I like them.
L.
Flew mine this evening for the first time, flew as I expected- Very well!!! Silk and dope with a Saito 70. Looking forward to getting used to the airplane and starting to set it up like I like them.
L.
#183
Senior Member
RE: BTE Venture 60
I changed the engine in mine from a super tiger 61 to an os 61 and I did not think it would improve much, but the plane became a lot more fun to fly. I was getting ready to sell the plane, but now I will have to keep it. ))