Corona 120 Converted to Bell 47 Helicopter
07-29-2010, 11:31 PM
#1
Thread Starter
My Feedback: (17)
Join Date: Oct 2002
Location: Las Vegas, NV
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
Corona 120 Converted to Bell 47 Helicopter
It was an idea that I played around with in my head for a while and I finally did it. Fabricating a bell 47 helicopter frame to fit Corona 120 Helicopter parts, See images below.
05-14-2012, 07:55 AM
#5
Thread Starter
My Feedback: (17)
Join Date: Oct 2002
Location: Las Vegas, NV
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
RE: Corona 120 Converted to Bell 47 Helicopter
Sorry I have no recording devices, but the Frame was made from Wooden Dowels, I was going to use aluminum tubing, but figured it might be too heavy, as for the bubble, it was hard to find any the right scale size, so I had to construct one from a clear christmas ornament, a large one in fact, you can purchase it here> http://factorydirectcraft.com/catalo..._ornament.html
it had to be glued together then the door openings cutout and the bottom cut off to leave a flat spot for the floor. the Cockpit instuments were printed from google images and shrunk in photoshop to fit a balsawood made instument board. use your imagination and it will turn out just fine..!
it had to be glued together then the door openings cutout and the bottom cut off to leave a flat spot for the floor. the Cockpit instuments were printed from google images and shrunk in photoshop to fit a balsawood made instument board. use your imagination and it will turn out just fine..!
