My new Q40 from HC molds
 

Hello everyone.

Just sharing my new racer.....

Its intended to be a Proud bird and adjusted to fitt Vendetta wings

I made from Hydrocal molds techinque.

Just flew it yesterday with very satisfactory results.

Regards
Oddy

RE: My new Q40 from HC molds
 

Looks good Oddy! How did you do the tail feathers?


BV

RE: My new Q40 from HC molds
 

Hi Bill, thank you very much.

Actually the tail feathers were not made by me, one friend pass me on a composite stab and rudder.

Regards.
Oddy

RE: My new Q40 from HC molds
 

Were are the cheek cowls? The real one had them and they went into the wings

RE: My new Q40 from HC molds
 

Hi Kevin, you are right,

These one didn´t have the cheek cowls as it was the first test fuselage to see if it flies OK.

They are considered for the following ones.

Oddy.

RE: My new Q40 from HC molds
 

Congratulations on your model! Looks good![sm=wink_smile.gif]

Is that your first fiberglass fuselage?

RE: My new Q40 from HC molds
 

Hi Sahartman21, thank you very much.

For a Q40 type yes its my first fuselage, anyhow previously I have made some Q500 and other kind of planes fuselages with the same Hydrocal molds technique.

Oddy.

RE: My new Q40 from HC molds
 

wow, nice. it's rare to see a thread here or elsewhere in the pylon forums that's not a for sale thread. please keep posting.