Help needed with programming Eurgle TX
09-28-2014, 04:34 AM
#1
Help needed with programming Eurgle TX
I have an Eurgle rcps61207 tx with the original firmware/software (they also make flysky, imax, turnigy and others).
I would like to program flaps to the AUX 3 position switch.
Various programs that I have seen (and tried) are for later versions of the firmware/software.
The manual offers no help (that I can find) for doing this.
Thanks,
Campy
I would like to program flaps to the AUX 3 position switch.
Various programs that I have seen (and tried) are for later versions of the firmware/software.
The manual offers no help (that I can find) for doing this.
Thanks,
Campy
