Futaba S9252 Problems
#1
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Sep 2003
Location: Burlington,
ON, CANADA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Futaba S9252 Problems
I'm flying a Aeroworks Extra profile and I have Futaba S9252 Servos installed with a Futaba R138DP reciever and a 9z WCII radio. I am having a huge problems with the servos when I turn the plane on the servos flap about a half inch on each side of the surface. When the plane is in the air it doesnt seem to be a problem but a 1600 mah pack (4.8v) will last 12 minutes. I was wondering if any one else has had this problem. any help would be greatly appreciated.
Thanks
Thanks
#3
Senior Member
My Feedback: (16)
Join Date: Apr 2002
Location: Locust Grove,
GA
Posts: 12,942
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba S9252 Problems
I would say you may have been overloading the receiver. Stand back a ways and see what happens. I was under the notion you could not do that with a PCM reciever but I could be wrong.
#4
My Feedback: (204)
Join Date: Jan 2002
Location: Va Beach, VA
Posts: 1,189
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba S9252 Problems
sounds like you have some serious binding going on with your linkages, for one when you turn on the radio it sounds like the servos straining to find a neutral which is why they would flap in both directions, two is, I believe 9252 are digitals, and digitals combined with binding linkages = accellerated battery drain BIG TIME!
#5
Senior Member
My Feedback: (-1)
Join Date: Apr 2003
Location: Phoenix, AZ
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba S9252 Problems
Is your pack MiMH or NiCAD? It says on the box of the servo you have to run 4.6V NiCAD ONLY. Im trying to figure out why, and this may be your problem...
#6
My Feedback: (5)
Join Date: Jan 2002
Location: San Tan Valley,
AZ
Posts: 5,768
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba S9252 Problems
ORIGINAL: KWH
I'm flying a Aeroworks Extra profile and I have Futaba S9252 Servos installed with a Futaba R138DP reciever and a 9z WCII radio. I am having a huge problems with the servos when I turn the plane on the servos flap about a half inch on each side of the surface. When the plane is in the air it doesnt seem to be a problem but a 1600 mah pack (4.8v) will last 12 minutes. I was wondering if any one else has had this problem. any help would be greatly appreciated.
Thanks
I'm flying a Aeroworks Extra profile and I have Futaba S9252 Servos installed with a Futaba R138DP reciever and a 9z WCII radio. I am having a huge problems with the servos when I turn the plane on the servos flap about a half inch on each side of the surface. When the plane is in the air it doesnt seem to be a problem but a 1600 mah pack (4.8v) will last 12 minutes. I was wondering if any one else has had this problem. any help would be greatly appreciated.
Thanks