9CAP TX LCD problem
#1
Thread Starter
My Feedback: (17)
Join Date: Dec 2002
Location: Calgary, AB, CANADA
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
9CAP TX LCD problem
I have 9C Tx, sometimes when I turned off the Tx, the LCD seems still on and became half blank and half black. I have to turn on and turn off again, then it shut down, why?
Anyone has same experience?
Jacky
Anyone has same experience?
Jacky
#3
Senior Member
Join Date: Aug 2002
Location: NearBy,
AZ
Posts: 2,409
Likes: 0
Received 0 Likes
on
0 Posts
9CAP TX LCD problem
I sometimes get the black lines and garbage on the screen when I shut the transmittler off also. The screen usually clears in a second or two..
#6
Thread Starter
My Feedback: (17)
Join Date: Dec 2002
Location: Calgary, AB, CANADA
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
9CAP TX LCD problem
Is there a Futaba rep. in this forum can explain this? Seems a lot people have same problem
I have sent two emails about this question to Futaba, but nobody can explain it and just told me can send it back for check.......
Jacky
I have sent two emails about this question to Futaba, but nobody can explain it and just told me can send it back for check.......
Jacky
#7
Senior Member
Join Date: Sep 2002
Location: Lancaster,
CA
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts