"inverse time feed mode" question...
#1
Junior Member
Thread Starter
Join Date: Jul 2007
Location: , CA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
"inverse time feed mode" question...
Hello,
CNC softwares like Mach has "inverse time feed mode (G93)".
Inverse time feed mode (G93) allows command to complete a movement in specified time (seconds)
In other words, you give a movement and specify the time in which this movement should be completed, let's say 1 second, then the software calculates all necessary variables (such as velocity etc.) and completes the movement on 1 second mark.
Are you aware of any RC servo (DC hobby servo) PC control softwares that have this capability?
I would so much appreciate your help.
Thank you.
CNC softwares like Mach has "inverse time feed mode (G93)".
Inverse time feed mode (G93) allows command to complete a movement in specified time (seconds)
In other words, you give a movement and specify the time in which this movement should be completed, let's say 1 second, then the software calculates all necessary variables (such as velocity etc.) and completes the movement on 1 second mark.
Are you aware of any RC servo (DC hobby servo) PC control softwares that have this capability?
I would so much appreciate your help.
Thank you.