Im New here, but this is my newest project
#1
Junior Member
Thread Starter
Join Date: Apr 2015
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Im New here, but this is my newest project
An HPI RS4 all aluminum. I was able to massage an aluminum flyweheel so that it would fit on the Novarossi .15 with the original 2 speed gear. I have a manifold and a pipe on order, so it should be finished and running in about a week. The engine is a discontinues Novarossi tx15. Should be a lot of fun and the extra 13k RPMs should give much better top end over the stock HPI engines that came in these.
#2
An HPI RS4 all aluminum. I was able to massage an aluminum flyweheel so that it would fit on the Novarossi .15 with the original 2 speed gear. I have a manifold and a pipe on order, so it should be finished and running in about a week. The engine is a discontinues Novarossi tx15. Should be a lot of fun and the extra 13k RPMs should give much better top end over the stock HPI engines that came in these.
#4
Junior Member
Thread Starter
Join Date: Apr 2015
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
I will weigh it. I am still looking for a manifold that will work for me. If I had an aluminum welder I could make the one for a traxxas tmaxx work, but I dont have aluminum welding capability right now.
#5
Junior Member
Thread Starter
Join Date: Apr 2015
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Well I found a local guy who will cut and reweld the flange which will just make the exhaust fit as if it was meant for this car!!! I will get pics up after the work is done
#9
Senior Member
Join Date: Sep 2007
Location: Cypress, TX
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
#13
Junior Member
Thread Starter
Join Date: Apr 2015
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
So far, I have gotten 62 MPH in a parking lot. It accelerates scary quickly, and I am nogga need to finish breaking in the engine and see just what I can get when its run lean.