RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: dtm360
Showing results 1 to 25 of 67
Search took 0.62 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-13-2011, 08:51 AM
Replies: 26
Views: 4,550
Posted By dtm360

RE: Frsky 2.4 Gig Question

The biggest problem with the Frsky?? the upper and lower halves of the Receiver cases are only snap fit. I've had one pop off in flight, found the top of the case inside the plane. I now run a drop...
Forum: Glow to Electric Conversions
02-04-2011, 06:02 AM
Replies: 27
Views: 5,815
Posted By dtm360

RE: The Wings Maker Clipped Wing Cub 48

I just did a conversion of this plane using 5s 3000mah with a Turnigy 4250-650kv motor. Flies really quite nice. To make the battery changes easier, I left a strip on the top of the windscreen to...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-22-2010, 08:12 PM
Replies: 4
Views: 1,058
Posted By dtm360

RE: 2.4 diy conversion

I have done a Corona DIY install and an Frsky DIY install, but on JR radios. The Corona is a little more difficult because of the antenna, it is a slightly better built unit (at least the LED and the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-25-2010, 01:00 AM
Replies: 3
Views: 1,835
Posted By dtm360

RE: DX8 Bind Problem

I've had the same problem with some of my Spektrum. They bind more consistently with 4.8v batteries rather than 6v batteries. No effect on normal performance though...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-25-2010, 12:36 AM
Replies: 36
Views: 6,306
Posted By dtm360

RE: 2.4 conversion confusion

In simple terms. If you buy a Futaba module, you will have to forever buy Futaba Receivers. If you buy an FrSky Module it will only work with FrSky receivers cannot mix with etc.etc....
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-25-2010, 12:31 AM
Replies: 36
Views: 6,306
Posted By dtm360

RE: 2.4 conversion confusion

For the FrSky module. You will only get 8 channels. But I bet if you work out the channel requirements of the RC Jet, you can "pair" a few of these with simple Y-harness to get the channel...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-25-2010, 12:28 AM
Replies: 36
Views: 6,306
Posted By dtm360

RE: 2.4 conversion confusion

You do not have to use a Futaba branded module for your 9C. If you buy a module from another brand. You do have to buy a module that is specified to work with your Futaba, this is because of modules...
Forum: RC Warbirds and Warplanes
07-23-2010, 08:32 AM
Replies: 250
Views: 51,707
Posted By dtm360

RE: *World Models 70

I have an old YS 120 in mine, it's a little overpowered for the plane. But boy does it fly nicely, sometimes you'd think it's a trainer. Dead easy to land even with cross wind!
Forum: Foamies! - RC Electric Foam Aircraft
07-18-2010, 06:14 PM
Replies: 10
Views: 9,209
Posted By dtm360

RE: Sbach 342 Foamie

Here's something for a little more inspiration.... floating around the Chinese websites, should be appearing as a household brand at some point in time!

...
Forum: Sport Flying
05-08-2010, 04:12 AM
Replies: 9
Views: 1,553
Posted By dtm360

RE: World Models Spot On 50

I've had 2 Spot On 50. One with a Magnum 70, which I felt was under powered and did not balance right (nose heavy). The current one with an AX55 and Pitts muffler. Balances better (although still...
Forum: RC Warbirds and Warplanes
05-03-2010, 09:55 AM
Replies: 72
Views: 7,798
Posted By dtm360

RE: Best flying war bird fighter?

I'm no warbird expert, but I recently put together a WM 1/7 scale P47. I was surprised how easy it is to fly, not entirely trainer like but still extremely easy to fly and land. I haven't had it nose...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-13-2010, 08:19 PM
Replies: 61
Views: 7,770
Posted By dtm360

RE: JR 11X RADIO ON CHIEF

I think this analogy throttle trim is an "American" thing rather than a "JR" thing. Everyone else in the world have had 4 digital trims on JR since 9303 or 9X...as the rest of the knows of it! [8D]
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-10-2010, 02:52 AM
Replies: 61
Views: 7,770
Posted By dtm360

RE: JR 11X RADIO ON CHIEF

The looks of the TX is definately an "acquired" taste.... however, if you hold one in your hands it is definately from a different planet BETTER! The sides are smooth and the weight is just perfect!...
Forum: ARF or RTF
03-25-2010, 12:28 AM
Replies: 4
Views: 1,209
Posted By dtm360

RE: Who Makes a Sukhoi ARF for 26cc gas?

Plenty of Sukhoi from here

http://www.peakmodel.com/index.php?main_page=index&cPath=1_99_96&sort=20a&page=3
Forum: ARF or RTF
03-02-2010, 10:02 AM
Replies: 5
Views: 1,001
Posted By dtm360

RE: What happened?

opjose is right, would look like you are drawing too much amps from your packs...rarely should they be HOT after a couple of minutes. Would recommend putting an wattmeter against the setup and see...
Forum: ARF or RTF
03-02-2010, 09:56 AM
Replies: 9
Views: 1,553
Posted By dtm360

RE: Peak models

It is a very well built model. I have the 25% SU31, the quality is excellent and makes the Hangar 9 stuff look poor! If your version has split landing gears, I would advise you to take out the...
Forum: ARF or RTF
01-18-2010, 12:26 AM
Replies: 7
Views: 2,830
Posted By dtm360

RE: World Models Ultimate 120

I have a YS 120 in mine. Flies fine. One thing to look out for is the covering, I have the purple and Silver version, both purple and silver does not stick very well, tape down all the leading edges...
Forum: RC Pattern Flying
12-21-2009, 07:28 AM
Replies: 62
Views: 22,509
Posted By dtm360

RE: Neptuno 170

Don't tell Alex, but here he is coming in to land in Hong Kong this weekend [8D]
Forum: ARF or RTF
07-26-2009, 09:29 AM
Replies: 4
Views: 1,682
Posted By dtm360

RE: Yak54 Peak Models

Landing gear, as ready mentioned needs re-inforcement. I ended up using a L shape aluminum piece to run across the both fuselage mounts in order to distribute the loads. Had one side fail on me...
Forum: RC Pattern Flying
07-06-2009, 09:55 PM
Replies: 151
Views: 33,881
Posted By dtm360

RE: Spot On 50 Build log.

Be careful that you do not have the original version...just the Spot On 50. In the original version, the leading edge of the wing which mate onto the fuse is tapered. In the R and N versions, they...
Forum: ARF or RTF
06-13-2009, 09:46 AM
Replies: 5
Views: 1,042
Posted By dtm360

RE: Can I use a Heli Engine on a Plane?

It will cost you one bullnose spinner because of the heli's short crank that will be it! You will also find the the carb on heli engines are better than airplane engines anyway! Do it!
Forum: YS Engines Support
06-10-2009, 10:59 AM
Replies: 3
Views: 1,006
Posted By dtm360

RE: Which YS120 do I have?

I checked the valve keepers and the engine does appear to be an NC.<div>
</div><div>Do you have any idea on the hole in the backplate? I'm beginning to think it is a home mod!</div>
Forum: YS Engines Support
06-08-2009, 06:51 AM
Replies: 3
Views: 1,006
Posted By dtm360

RE: Which YS120 do I have?

Here's a couple of pics of the rear cover.
Forum: YS Engines Support
06-08-2009, 06:32 AM
Replies: 3
Views: 1,006
Posted By dtm360

Which YS120 do I have?

Hi,

Can you guys help. I won this engine on ebay! At first I thought it was a 120NC, but if you look closely at the picture, the front nipple, topressurisethe tank has been blanked off with a...
Forum: ARF or RTF
06-04-2009, 06:57 AM
Replies: 8
Views: 2,792
Posted By dtm360

RE: NEMESIS 52 WORLD MODELS

Alternatively, just get it direct from Hong Kong!<div>
</div><div>http://ecsvr.com/twm/ShopDisplayproducts.asp?Search=Yes</div>
Showing results 1 to 25 of 67
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.