RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: MatiasR
Showing results 1 to 24 of 24
Search took 0.66 seconds.
Forum: Gas Engines
04-06-2012, 05:54 AM
Replies: 41
Views: 3,790
Posted By MatiasR

RE: Mark/Moki Engine's

Dear all,
let me clarify a few things: The first series of the Moki/Mark 180 gas engines was shipped with a German-made ignition (manufactured by JWE). This ignition has a different logic than most...
Forum: Glow Engines
02-09-2010, 06:45 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Hi Bill,
theoretically you can buy the Mark engines from me (I carry the 140, 180, 210, 360 alcohol versions and the 140, 180 and 360 gas versions, and I have a few of the .61 methanol engines...
Forum: Glow Engines
12-24-2009, 10:50 AM
Replies: 11
Views: 7,685
Posted By MatiasR

RE: OS 300 Twin versus Saito 300 Twin

CorsairJock,
good luck with the engine. I also use a glow driver - Paul Telco's "TWIG" Intelligent Glowdriver (the newer version now is called AGS-2). It measures the temperature of the glow plug...
Forum: Glow Engines
12-24-2009, 09:32 AM
Replies: 11
Views: 7,685
Posted By MatiasR

RE: OS 300 Twin versus Saito 300 Twin

Hi CorsairJock,
I've never tried a three-blade on my Saito, but the rule of thumb says that the 20x11.5 3-blade will correspond roughly to a 22x11 2-blade- which is a LOT of prop for the engine...
Forum: Glow Engines
12-22-2009, 05:18 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Ringed or unringed - a philosophical question....

The ABC version probably has a slight power / performance advantage over the ringed version, HOWEVER, is more critical when it comes to thermal...
Forum: Glow Engines
12-22-2009, 04:03 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Hi Sonnich,
now it will get a bit complicated:

During the communist time in Hungary, the Hungarian Army established an institute for the development and research of model engines - in...
Forum: Glow Engines
12-22-2009, 05:16 AM
Replies: 11
Views: 7,685
Posted By MatiasR

RE: OS 300 Twin versus Saito 300 Twin

Hi Tommy,
I have the single carb version of the Saito. I have been flying it a lot with an APC 20x10 wide blade, a Mejzlik carbon 20x10 as well as with an APC 22x8. With all these propellers I had...
Forum: Glow Engines
12-22-2009, 05:03 AM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Hi Raybow,
the problem is, that the Moki 61 is out of production since several years. The engines from the last production run were bought up by several Moki/Mark resellers (amongst myself). I...
Forum: Glow Engines
12-21-2009, 07:12 PM
Replies: 17
Views: 3,870
Posted By MatiasR

RE: Recommend airplane for Moki 210...?

Hi there,
5% Nitro will do fine. Use an O.S. "F" plug, and at least 17% synthetic or 20% castor. My favourite propeller is an APC 20x10, and I'm running a tuned pipe wit about 31" length (measured...
Forum: Glow Engines
12-21-2009, 07:06 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Hi guys,
I'm still around. :D

I have >10 M61 NIB on stock, all versions, i.e. ABC and ringed, as well as side or rear exhaust. @Raybow - which version are you looking for?

Happy...
Forum: Gas Engines
10-18-2007, 05:14 AM
Replies: 14
Views: 5,138
Posted By MatiasR

RE: Moki/Mark G180 Gas Anyone flying this engine

...that's the newer, Hungarian ignition (in my mind better than the German JWE, as it supports higher revs).

The hose between crank case and pump is a clear, rigid piece of fuel tubing. The...
Forum: Gas Engines
10-18-2007, 03:06 AM
Replies: 14
Views: 5,138
Posted By MatiasR

RE: Moki/Mark G180 Gas Anyone flying this engine

...which ignition box do you have - the German JWE or the Hungarian one?

On the carb issue - if you put your finger on the carb throat and flip the prop, the engine should be drawing the fuel...
Forum: Gas Engines
10-17-2007, 12:15 PM
Replies: 14
Views: 5,138
Posted By MatiasR

RE: Moki/Mark G180 Gas Anyone flying this engine

...no, not really. It may be in case someone wants to set up the fuel line with access fuel flowing back to the tank. If your walbro has such a tube, try plugging it and see if the pumping...
Forum: Gas Engines
10-17-2007, 05:01 AM
Replies: 14
Views: 5,138
Posted By MatiasR

RE: Moki/Mark G180 Gas Anyone flying this engine

@jjcollett: "After starting it runs really well, idles well, and transitions well. I am using a JTEC sport muffler with a low profile for a G23 for future cowl fitting."

A muffler designed for a...
Forum: RC Pattern Flying
10-01-2007, 10:18 AM
Replies: 4
Views: 2,310
Posted By MatiasR

RE: Azzurro

Hi Kjeld, better late than never....

Azzuro is a 186 cm F3A-like design, it is available from Beineke Modellbau in Germany. The kit costs 139 €. We fly several models of Beinek in our club (I...
Forum: Gas Engines
09-17-2007, 11:59 AM
Replies: 14
Views: 5,138
Posted By MatiasR

RE: Moki/Mark G180 Gas Anyone flying this engine

Hi, I'm flying one since two years in Germany, and have run several gallons of fuel through. I also fly all glow versions (M135 / M180 / M210).

It is true that this is a conversion of the glow...
Forum: Glow Engines
06-05-2005, 02:35 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Hi Chipichape,
unfortunately the situation is not as simple as it looks - the companies "Remek" and "Moki" no longer belong together. I don't want to go into painful details, but the Remek page is...
Forum: Glow Engines
01-02-2005, 06:11 PM
Replies: 36
Views: 8,284
Posted By MatiasR

RE: Will glow plugs go bad with age?

... I would rather think that your fuel has gone bad. Methanol (the alcohol in our glow fuels) is very hygroscopic, i.e. it absorbs water (humidity from the air). I have plugs that are many years old...
Forum: Glow Engines
01-02-2005, 06:08 PM
Replies: 40
Views: 20,849
Posted By MatiasR

RE: MOKI ENGINES

Dear all,
let me try to get some things sorted out here...

1.) "Moki" still exists. It is ONE of the brands used by a Hungarian model engine manufacturing company, just as well as "Mark". The...
Forum: The Clubhouse
11-08-2004, 04:33 PM
Replies: 68
Views: 7,459
Posted By MatiasR

RE: international flyers

Hi Gringo, here's some additions to your list:

I am of Hungarian origin, but was born in Venezuela, lived in Uruguay, The Netherlands, Hungary and Germany. My flying experience is limited to...
Forum: The Clubhouse
11-08-2004, 04:24 PM
Replies: 15
Views: 2,030
Posted By MatiasR

RE: Newbee

I built a NewBee last summer and enjoyed it flying with an O.S. FS 26, until I heard of the new Saito FA40a. Just a tad heavier than the O.S., it has significantly more power (10.000 rpm on an APC...
Forum: Batteries & Chargers
01-15-2003, 08:52 PM
Replies: 4
Views: 785
Posted By MatiasR

Lowest voltage for flying?

Due to the characteristics of the NiCd-cells, a voltage reading of a battery pack without load is quite meaningless. Even a completely drained cell (0.8 Volts under load) will return to an idle...
Forum: Glow Engines
12-28-2002, 12:07 PM
Replies: 11
Views: 989
Posted By MatiasR

Moki 1.8 Problems

What type of muffler are you using? Burning plugs can also mean you have too much backpressure in your exhaust system, or, if you are using a tuned pipe, the pipe is too short.

In any case fried...
Forum: RC Scale Aircraft
12-27-2002, 07:35 AM
Replies: 0
Views: 764
Posted By MatiasR

Midwest Super Stinker

Hi Jacko,
I have a Super Stinker and all plans. I live in Germany. Please drop me an e-mail ([email protected]) and I can send you scans of the parts you are looking for.

Matias
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.