RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: goshawk911
Showing results 1 to 21 of 21
Search took 0.53 seconds.
Forum: RC Jets
12-25-2022, 03:29 AM
Replies: 79
Views: 31,148
Posted By goshawk911

hi jeff using the old elevators and struggle to...

hi jeff
using the old elevators and struggle to land it so with the C of G at 6.75” and trimmed for about 2 degrees of nose up with full flap. Using a little bit of power it now comes in nice with...
Forum: RC Jets
12-21-2022, 04:54 AM
Replies: 79
Views: 31,148
Posted By goshawk911

T33

Hi
I was having the same issue landing. I trimed the jet using flight modes with a slight nose up on full flap. This made all the differnce it will now land at walking pace with a little trottle on....
06-26-2020, 01:09 AM
Replies: 125
Views: 39,307
Posted By goshawk911

Very nice mate. All about the same as mine. Its...

Very nice mate. All about the same as mine. Its exclent flyer I have 15 flights on mine now
06-15-2020, 12:50 AM
Replies: 125
Views: 39,307
Posted By goshawk911

Nice Work on P-47. I set mine to 155mm and for me...

Nice Work on P-47. I set mine to 155mm and for me its just about right. I have to push forward a little when inverted and it come out of barrel rols with very little input on the elevator.
At this C...
05-16-2020, 06:30 AM
Replies: 125
Views: 39,307
Posted By goshawk911

Hi as restrictions have lifted a little in...

Hi
as restrictions have lifted a little in England we are now able to fly. I managed to get 2 flights in on the P-47 and I have to say it’s very nice to fly. I ended up with around 25mm up and down...
05-07-2020, 11:40 PM
Replies: 125
Views: 39,307
Posted By goshawk911

Hi P-47 are normally ok. Watch the yaw on take...

Hi
P-47 are normally ok. Watch the yaw on take off as it will want to pull to the left. You will probably need a fair bit of rudder to keep it tracking straight. Let the tail rise and balance it on...
05-07-2020, 12:52 PM
Replies: 125
Views: 39,307
Posted By goshawk911

hi i had this engine in my Corsair and ran it...

hi
i had this engine in my Corsair and ran it with a 24x10. I find with warbirds that the bigger the prop the better. If it will spin a 24x10 then go with that. You don’t want it over reving as they...
05-06-2020, 11:36 PM
Replies: 125
Views: 39,307
Posted By goshawk911

Hi i only have the same manual as you. i...

Hi
i only have the same manual as you.
i think 45 degrees is to much for the ailerons to.
a bit more info would be useful for both of us.
is you C of G where the manual states.
good luck with...
05-06-2020, 12:36 AM
Replies: 125
Views: 39,307
Posted By goshawk911

its a Saito 84R 3 cylinder 👍

its a Saito 84R 3 cylinder 👍
05-05-2020, 02:38 PM
Replies: 125
Views: 39,307
Posted By goshawk911

Looking for some info to

I have been putting one of these together for the last few months.
nearly ready now. If anyone has managed to fly there’s would be interesting to know C of G and throws they are using and how it...
07-27-2016, 06:10 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Hi Adam I used the system from Adrian at...

Hi Adam

I used the system from Adrian at CH-Ignitions. It definitely improved the reliability at tick over and it produced around 200-300 more RPM at full throttle.
I tried just about everything...
07-27-2016, 05:25 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Hi Adam Just a bit of info. I have had this...

Hi Adam

Just a bit of info. I have had this corsair for nearly 2 years now. I started with the Evo 7Cyl and flew it for a season. Has lots of issues with power and over heating.
Converted the...
Forum: RC Jets
10-12-2015, 01:15 AM
Replies: 12
Views: 1,321
Posted By goshawk911

Great day once again Dave. Look forward to next...

Great day once again Dave. Look forward to next one.

Cheers

Tim
01-28-2015, 01:26 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

I had this issue to. I adjusted mine on the...

I had this issue to. I adjusted mine on the scissor part of the retract, this worked for me.
01-20-2015, 01:26 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Well Said njmheli Like I said in my earler...

Well Said njmheli

Like I said in my earler post I went with 24x10 2 as it gave the best performance for me. I check the RPM every time I fly it. Air Temp has an effect on overal performance and I...
01-19-2015, 09:23 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

A 22x14 may be worth a try. Hadn't thought of...

A 22x14 may be worth a try. Hadn't thought of going that high on the pitch. I may try and get hold of one and see what I get
01-19-2015, 08:51 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Let me know how you get on with the conversion. I...

Let me know how you get on with the conversion. I would test fly it with a 24/10 2 as I know that's a good combo. I have tried Xoar and Beila. The 24x10 is a xoar.
You may find that with the CDI...
01-19-2015, 07:54 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

With the 23x10 3 I get a max RPM 5600. lots RPM...

With the 23x10 3 I get a max RPM 5600. lots RPM not much pull. With the 24x10 2 I get a max RPM of 5300 but lots more pull.
The 23/12 drops the RPM down to 5100 again not as pull as the 2 blade. I...
01-19-2015, 07:20 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Hi I have been flying my Corsair with the...

Hi

I have been flying my Corsair with the 7-77 for the last 10 months. I have tried 23x12 3 and a 23/10 3. Ended up with using 24/10 2. This gave the best performance in the air. Take offs runs...
09-03-2014, 08:00 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

Its a scale detail. In the full size it was the...

Its a scale detail. In the full size it was the step for the pilot to get up to the cockpit
07-24-2014, 08:14 AM
Replies: 2,806
Views: 635,685
Posted By goshawk911

I have flown mine so far on 24x10 2 blade and...

I have flown mine so far on 24x10 2 blade and Biela 3 Blade 22x12 better on the 24x10 to be honsest, not sure about 18x14 I should think it only just sticks out from the cowl.
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.