RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: crashngo
Showing results 1 to 25 of 32
Search took 0.71 seconds.
Forum: Beginners
03-31-2003, 02:53 AM
Replies: 7
Views: 758
Posted By crashngo

LT40 Battery/fuel tank

The following pictures show the battery pack which is attached to a piece of scrap and then cut off, giving it a little handle to help pull it from the nose area below the tank deck if needed, pic...
Replies: 7
Views: 667
Posted By crashngo

ENCODER

Noted previously by Lynx in regard to encoders, was the addition of channels. Where is this information available. Is this going to be a math project to extract unused binary freespace stored in...
03-22-2003, 04:18 AM
Replies: 3
Views: 449
Posted By crashngo

avatar

Thank's Plane Insane, I'll try that. Jerry
Forum: The Clubhouse
03-22-2003, 04:08 AM
Replies: 47
Views: 3,282
Posted By crashngo

U.S. NAVY

Former E-6 SQUID God speed to all sailors and may Neptune keep an eye out. FFG-16 FFG-51 (Gas turbine ships haul arse!)
03-22-2003, 04:01 AM
Replies: 3
Views: 449
Posted By crashngo

avatar

Sure would like an avatar but no matter what I try I can't seem to get to the right size, I can get down to 320x240, which is what I use to post ad's with, but if I try the arbitrary size (make...
Replies: 7
Views: 667
Posted By crashngo

Buddy Box

Appreciate the input from all of you. Very informative, will try the test as suggested by Strato911. Thank's again Jerry
Replies: 7
Views: 667
Posted By crashngo

Buddy Box

So, if my 6 channel Futaba is connected to a 4 channel Futaba the 4 channel will ignore the additional inputs from the 6 and perform only it's known functions?
Replies: 7
Views: 667
Posted By crashngo

Buddy Box

Lets say my Futaba 6channel is hooked to a another Futaba radio with the buddy cord, will, let's say the retract switch and others work through the other radio if it is not equipped with the same...
Forum: The Clubhouse
03-17-2003, 09:46 PM
Replies: 8
Views: 688
Posted By crashngo

PAY PAL

Just thought I'd add my 2 cents worth. One thing to remember in dealing on e-bay is to be aware of the seller. A few things to look for are the numbers of good feedback given to the seller. Low...
Forum: Beginners
03-13-2003, 01:15 PM
Replies: 8
Views: 1,065
Posted By crashngo

Rudder Control Horn Position LT-40

Also note that the pushrod will be at somewhat of an angle to the rudder after it comes out of the fuse. I added this slight angle when mounting the control horn. jerry
Replies: 2
Views: 470
Posted By crashngo

Trainer Switch

Got Ya'
Replies: 2
Views: 470
Posted By crashngo

Trainer Switch

Are most trainer switches momentary or are there others that will stay in that position. My Futaba Conquest is a momentary. Just wondered. Jerry
Forum: Beginners
03-07-2003, 06:41 PM
Replies: 26
Views: 2,202
Posted By crashngo

Are you building a sig LT-40 Now ?

djse7en, Just a follow up to the question on my yellow LT-40, The engine is an OS-46LA, radio is Futaba Conquest as well as Futaba servos. Actually bought the radio and servos from another RCU...
Forum: Beginners
03-06-2003, 03:32 AM
Replies: 26
Views: 2,202
Posted By crashngo

Are you building a sig LT-40 Now ?

looking foreward to that day. now if this snow would just leave.
Forum: Beginners
03-06-2003, 01:08 AM
Replies: 26
Views: 2,202
Posted By crashngo

LT-40

Finishing this one up
Forum: Beginners
03-03-2003, 03:51 AM
Replies: 10
Views: 1,245
Posted By crashngo

Fuel sys.

And here's the final set up, clean and functional, remote glow plug connection, charge port, on-off and the remote fueler.
Forum: Beginners
03-03-2003, 03:44 AM
Replies: 10
Views: 1,245
Posted By crashngo

Fuel Sys.

Better shot.
Forum: Beginners
03-03-2003, 03:35 AM
Replies: 10
Views: 1,245
Posted By crashngo

Check Valve

Then I installed a check valve in the fill line, the line however is above tank height.
Forum: Beginners
03-03-2003, 03:32 AM
Replies: 10
Views: 1,245
Posted By crashngo

Remote Fueler

Here's the setup on a sig LT-40 I'm building, third line goes rear for the fill. One to the muffler and other to carb with filter.
Forum: The Clubhouse
03-02-2003, 11:10 PM
Replies: 18
Views: 1,789
Posted By crashngo

Flying Chair

This thread title reminded me of a guy some years ago that had strapped himself and small weather type balloons to his lawn chair and took off, gained apparently significant altitude, enough to get...
Forum: Beginners
03-02-2003, 10:09 PM
Replies: 21
Views: 1,533
Posted By crashngo

SIG LT-40

Here's my take on one, has the O.S. 46LA, just about done with it. Jer
Forum: Beginners
03-02-2003, 01:33 AM
Replies: 6
Views: 534
Posted By crashngo

Servo Question

Had a look, RX is a FPR 127 DF, TX has the gold seal and both components are FM Thank's for the extra input. Jer
Forum: Beginners
02-27-2003, 08:57 PM
Replies: 6
Views: 534
Posted By crashngo

Servo Question

Appreciate the info, got hooked up a with a good club that has a nice 5 acre field. Been going through the paces with the G2 simulator. Final destination is warbirds with any luck. Thank's Jerry
Forum: Beginners
02-27-2003, 07:17 PM
Replies: 6
Views: 534
Posted By crashngo

Servo Question

Purchased a used Futaba(Conquest) radio and servo set for my SIG-LT40 kit, all seems to work just fine, question- what are the real differences in some of these servo's. I have a set of FP-S28'S and...
Forum: The Clubhouse
02-25-2003, 02:55 PM
Replies: 52
Views: 4,319
Posted By crashngo

(Paid) Flight Instructor

Are these people dropping out due to lack of interest you think or what. The cost add's up though, but I think I'd try something different before calling it quits.
Showing results 1 to 25 of 32
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.