RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: ucme2fly
Showing results 1 to 13 of 13
Search took 0.22 seconds.
05-04-2024, 01:32 PM
Replies: 3
Views: 120
Posted By ucme2fly

Thanks. Just what I needed. I have a spray gun...

Thanks. Just what I needed. I have a spray gun and airbrush.
05-03-2024, 02:13 PM
Replies: 3
Views: 120
Posted By ucme2fly

Need Hot Fuel Proof paint

I fly glow fuel and crashed a big Ryan STA. I'm in the process of repairing the fiberglass cowl, and need to repaint it. Its Aluminum colored. Looking for a rattle can clearcoat and paint that is...
01-16-2024, 01:41 PM
Replies: 6
Views: 452
Posted By ucme2fly

So Help me understand what to do with my 3 AR7000...

So Help me understand what to do with my 3 AR7000 receivers+satellites with this new NX10. Can they be used safely?
01-15-2024, 08:45 PM
Replies: 6
Views: 452
Posted By ucme2fly

Spectrum NX10 Binding

Just bought a new NX10. Binding it to all my planes. The planes with AR7000 (with a satellite) receivers bind as expected... UNTIL: If I turn off just the plane, and keep the transmitter on, both...
Replies: 6
Views: 343
Posted By ucme2fly

Thanks. That is very helpful. Makes good sense...

Thanks. That is very helpful. Makes good sense now. I will do exactly that. Final question for you... With ten digital servos how would you power the 42% with A123 batteries? What mah. size would...
Replies: 6
Views: 343
Posted By ucme2fly

Thanks Andy, I will do just that. One question...

Thanks Andy, I will do just that. One question though... The IBEC is ONLY for the (Desert Aircraft) ignition correct? Not run between the batt and the receiver...?
Replies: 6
Views: 343
Posted By ucme2fly

Question Help power my big 42% gasser

I built a big gas powered plane with 10 digital servos back in the 80's. Now I am getting back into flying, and need a radio system and batteries. All my old stuff is FM, and or totally obsolete, so...
02-24-2010, 01:37 PM
Replies: 10
Views: 1,163
Posted By ucme2fly

RE: 2.4 radio jitters

I contacted Spectrum on this and they told me that it is a normal condition found often on the Futaba receivers, but olso seen on their JR's too! So I guess I will go ahead and fly. It does not do it...
02-20-2010, 02:11 PM
Replies: 8
Views: 992
Posted By ucme2fly

RE: hobbico charger question

Huck is giving good advice. That is the charger I have been using on my Li-ios, Li-pos,and Nimh's for years. You can get any balancer for around $30. I like to balance during the charging, for a full...
02-12-2010, 07:58 PM
Replies: 10
Views: 1,163
Posted By ucme2fly

2.4 radio jitters

I justbuilt a42% Extra with a Spectrum 7ch receiver and transmitter module in my Futaba 9CAP. All the servos jitter bad for a couple seconds when you turn on the airplane. Both the satellite and the...
Forum: IMAC
02-12-2010, 06:49 PM
Replies: 1
Views: 1,040
Posted By ucme2fly

2.4 gitters at turn on

I justbuilt a42% Extra with a Spectrum 7ch receiver and transmitter module in my Futaba 9CAP. All the servos jitter bad for a couple seconds when you turn on the airplane. Both the satellite and the...
02-12-2010, 05:33 PM
Replies: 79
Views: 21,387
Posted By ucme2fly

RE: Mike Hurley EXTRA 300 build!!!

I built that bird back then, and I am still flying it. It is really a sweet airplane. Good luck, Be careful not to get the tail heavy. My DA 100 needed about a half inch of standoff for CG. Also...
12-21-2009, 06:01 PM
Replies: 3
Views: 504
Posted By ucme2fly

LITE 42% pilot bust

I have a CG issue and need a 42% light pilotbust to minimize aft C.G. increase. Between jobs now so I need a bargain too!
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.