RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: gsmarino2000
Showing results 1 to 25 of 340
Search took 0.68 seconds.
Forum: RC Jets
06-08-2020, 12:10 PM
Replies: 3,662
Views: 598,523
Posted By gsmarino2000

Hi airborne900, It's good to see some...

Hi airborne900,

It's good to see some activity. I built one of the Navy Cat carbon-reinforced version with the trailing link mains about 6 years ago and used it to get my waiver. I have about...
05-04-2020, 05:42 PM
Replies: 1
Views: 744
Posted By gsmarino2000

JR 11x to DX18 Transfer

This has probably been mentioned before, but if so I can't find it. Is there any way to transfer models from a JR 11X to a DX18 gen 2? You can save the models to the same SD card but the DX18 just...
07-31-2018, 06:24 PM
Replies: 7
Views: 4,258
Posted By gsmarino2000

I had a similar problem once with my 100 … was...

I had a similar problem once with my 100 … was caused by a small pinhole in the fuel line where there was a burr at on one of the filter nipples. You could barely detect the leak but the tiny hole...
Forum: RC Jets
04-20-2018, 06:02 PM
Replies: 297
Views: 68,419
Posted By gsmarino2000

[/left]I had problems with wing pin alignment. I...

[/left]I had problems with wing pin alignment. I ended up pulling out and replacing one pin and reworking the mounting for another. Now the wing installation is smooth. With a Kingtech 180 and 3...
01-03-2018, 07:27 AM
Replies: 9
Views: 2,805
Posted By gsmarino2000

For the same turbojet engine, the square-law RPM...

For the same turbojet engine, the square-law RPM relationship generally holds true for static thrust. Try knocking it down to 110,000 and measure the static thrust with a fish scale ... I think you...
01-02-2018, 12:54 PM
Replies: 9
Views: 2,805
Posted By gsmarino2000

I'm with jctpro - I like my jets a bit...

I'm with jctpro - I like my jets a bit overpowered and I wouldn't worry about 16% more thrust on a 210 vs. a 180. I find it pretty easy to enjoy the power in the vertical up direction without...
11-10-2017, 08:10 PM
Replies: 6
Views: 4,145
Posted By gsmarino2000

The original G1 Kingtech's used a Xicoy ECU,...

The original G1 Kingtech's used a Xicoy ECU, which in my experience works fine. I have three G1 Kingtech's and have had one flameout in the air in 200 or 300 flights. That flameout occurred on...
09-11-2017, 05:57 PM
Replies: 2
Views: 1,125
Posted By gsmarino2000

Pressure ratio doesn't have anything to do with...

Pressure ratio doesn't have anything to do with thrust - you could have the same pressure ratio on a 22 lb thrust turbine and a 22000 lb thrust turbine. A modern, single stage centrifugal compressor...
Forum: RC Jets
04-25-2017, 08:03 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Thanks, Jason. That makes sense for the cracking...

Thanks, Jason. That makes sense for the cracking above the gear, but the 2" long section collapsed on the leading edge ... hard to get behind. I guess I could take out a section further back and...
Forum: RC Jets
03-27-2017, 07:56 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

All, I had an incident on landing approach this...

All, I had an incident on landing approach this weekend. Followed my usual pattern for landing to the south, pulled back to about 1/4 throttle on the base leg and found myself too low and slow so...
Forum: RC Jets
12-30-2016, 05:40 PM
Replies: 36
Views: 3,809
Posted By gsmarino2000

Kingtech has a couple of specific turbine oils...

Kingtech has a couple of specific turbine oils they exclude due to observed coking problems, and I think all 2-stroke motorcycle oils. But to the best of my knowledge they do not require you to use...
Forum: RC Jets
11-08-2016, 05:58 AM
Replies: 28
Views: 10,101
Posted By gsmarino2000

I find that the 12 channel Powersafe does...

I find that the 12 channel Powersafe does everything I need for mid sized jets. I use LiFe batteries exclusively and the voltage level is not a problem for any of the equipment I am using. That's...
Forum: RC Jets
09-24-2016, 09:47 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

easyyou, Since I was going fast, obviously I...

easyyou,

Since I was going fast, obviously I did pull too hard in the turn and I exceeded the critical angle of attack, no question. However I am fully aware that jets are not good for "yank and...
Forum: RC Jets
09-24-2016, 06:36 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Hey guys, Some of you may remember that I...

Hey guys,

Some of you may remember that I had a landing in a corn field during the summer of 2015 due to a snap out that recovered too low. I ended up replacing the kit with my current Canadian...
Forum: RC Jets
06-10-2016, 07:52 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Scaryxxl, To the best of my knowledge the JL...

Scaryxxl,

To the best of my knowledge the JL brake valves are on/off and do not have anti-locking or pulsed mode. I keep my brakes lubricated with Vaseline and I modulate the switch by hand as...
Forum: RC Jets
06-02-2016, 05:10 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Ceeray, Sorry about the loss of your JTM...

Ceeray,

Sorry about the loss of your JTM Viperjet. I have had no issues at all with the Jet Legend version, however I normally fly pretty smoothly. I will say that there are quite a few of these...
Forum: RC Jets
06-02-2016, 04:08 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

No manual is typical for jets. This forum is...

No manual is typical for jets. This forum is better than any manual IMO, however it does take some time to dig through it. I don't have the lights, but I run everything on my jets and gas planes...
05-24-2016, 06:01 PM
Replies: 78
Views: 5,408
Posted By gsmarino2000

Homeland Security on UAV "Emerging Threats"

Received this today from the Homeland Security website - UAV "Emerging Threats." We track the site due to our own Cyber Security projects.

Greg
Forum: RC Jets
04-28-2016, 10:48 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

I know that the JL UAT looks a bit crude, but it...

I know that the JL UAT looks a bit crude, but it works just fine. I used it my first viper for ~ 46 flights and never an issue. Mine was cracked in my cornfield landing. Since I just bought a bare...
Forum: RC Jets
04-26-2016, 05:24 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

The P100 should have plenty of thrust; my K100...

The P100 should have plenty of thrust; my K100 flies the Viperjet with authority. Like a lot of others on this thread, I run fuel in the two smoke tanks and in one 1.5 l tank in front of the...
Forum: RC Jets
03-28-2016, 07:31 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Check it with air in it as you said and check...

Check it with air in it as you said and check again. Mine moves in all directions, maybe 1/8" or 3 mm measured at the bottom of the tire. Most of the movement is in the steering pin bearing. ...
Forum: RC Jets
03-28-2016, 10:47 AM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Simon, How do you mean "play"? My gear has...

Simon,

How do you mean "play"? My gear has about 50 flights and the pin which rotates to allow the nose gear to steer is a bit looser than I would like in the retract. Not causing any issues...
Forum: RC Jets
03-08-2016, 06:31 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

Greg, She flies great - my favorite is back...

Greg,

She flies great - my favorite is back :) Only needed 2 clicks of up trim and she was straight and smooth. There is a reason that I built another JL Viper rather than doing something...
Forum: RC Jets
03-07-2016, 06:00 PM
Replies: 1,801
Views: 360,896
Posted By gsmarino2000

I switched from the red tips that came with the...

I switched from the red tips that came with the Canada scheme to the white wing tips from my original Ferrari airframe. I don't think they look quite as good on the ground, but it does improve...
Forum: RC Jets
02-20-2016, 09:14 PM
Replies: 3
Views: 1,534
Posted By gsmarino2000

That's a steam turbine, not a gas turbine. They...

That's a steam turbine, not a gas turbine. They are very easy to overspeed.
Showing results 1 to 25 of 340
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.