RCU Forums - Search Results

Search: Posts Made By: MacofTampa

Showing results 1 to 4 of 4
Search took 0.02 seconds.

Forum: Speed - Electric

05-04-2016, 05:17 AM

Replies: 3,285

Unofficial "NQD" Tear into Jetboat Thread

Views: 607,077

Posted By MacofTampa

I thought there was a mod to install a bearing to...

I thought there was a mod to install a bearing to support the impeller shaft between the rubber seal and the motor coupler. I thought I saw something in this tread talking about it but not much...

Forum: Speed - Electric

05-03-2016, 02:38 PM

Replies: 3,285

Unofficial "NQD" Tear into Jetboat Thread

Views: 607,077

Posted By MacofTampa

I tore apart the NDQ and re-measured the motor...

I tore apart the NDQ and re-measured the motor shaft and you are correct I need a new coupler and I would like to add the bearing mod to the pump....I'll be looking for sources for both....If you...

Forum: Speed - Electric

05-03-2016, 12:36 PM

Replies: 3,285

Unofficial "NQD" Tear into Jetboat Thread

Views: 607,077

Posted By MacofTampa

sundogz, thanks for the reply....I...

sundogz,

thanks for the reply....I measured the shaft last night and it was 2.3 mm. I just got the Tear Into a few minutes ago and I'll test fit it once I get it apart....Thanks again I'm sure...

Forum: Speed - Electric

05-02-2016, 02:44 PM

Replies: 3,285

Unofficial "NQD" Tear into Jetboat Thread

Views: 607,077

Posted By MacofTampa

Hello I'm new to the NQD world, I have a motor...

Hello I'm new to the NQD world, I have a motor and ESC from a Losi Mini 8ight-T. Its a Dynamite Fuze 4500kv, I plan on reining this on 2S. My question is am I just trying to use what I have on hand...

Showing results 1 to 4 of 4