RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: dannydaville
Showing results 1 to 18 of 18
Search took 0.64 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-20-2006, 06:46 PM
Replies: 7
Views: 2,181
Posted By dannydaville

RE: Using Lipo For My Futaba 9C

Duraflitebatteries.com makes a Tx lipo battery specifically for the Futaba 9C.

Dan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-29-2004, 05:22 PM
Replies: 18
Views: 1,398
Posted By dannydaville

RE: Were is the BEST PLACE TO BUY HITEC EQUIPMENT?

Try www.hobbyhorse.com in Madison, WI They also have free shipping on purchases over $100.00
Forum: Batteries & Chargers
01-29-2004, 05:10 PM
Replies: 2
Views: 575
Posted By dannydaville

RE: Alpha 4, Triton, and SuperNova technical question

The Alpha4 does NOT employ the use of reverse or "burp" charging. I cannot say for the Triton or Super Nova as I don't own either one.
Forum: Batteries & Chargers
01-28-2004, 11:45 AM
Replies: 14
Views: 802
Posted By dannydaville

RE: Time in hours for my batteries with this charger...

Check out Dave Thacker's website at www.radicalrc.com He says to charge at a minimum of 140% for ni-cads (will work for nimh packs as well as long as its at C/10 rate) Therefore your figure of 1.4...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-24-2004, 03:00 PM
Replies: 17
Views: 894
Posted By dannydaville

RE: Got my new 9cap

Patriot,

Your 9CAP is programable for both PPM (FM) and PCM. The answer to your question is yes since its the same frequjency as your TX, as long as you program the TX to PPM for that model,...
Forum: Batteries & Chargers
01-24-2004, 02:44 PM
Replies: 3
Views: 684
Posted By dannydaville

RE: battery help!

Humpski,

Your charger outputs 6v DC at 120 mah. Your Nimh battery pack is rated at 1800 mah and that you should charge this pack for 15 hours at 180 mah. Since your charger can only put out...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-12-2004, 04:41 PM
Replies: 5
Views: 591
Posted By dannydaville

RE: Charge Rate thru Transmitter

Les,

As far as damage to the TX, you'd have to check with Futaba on that or some other expert in the field. To be on the safe side, you could always remove the pack from your TX at the field...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-12-2004, 03:03 PM
Replies: 5
Views: 591
Posted By dannydaville

RE: Charge Rate thru Transmitter

Tx battery packs should be charged at the overnight rate of C/10 which in your case would be 165 mah. 1.6A that you suggest is at the C/1 rate. If your charger has peak detection then you had...
Forum: Batteries & Chargers
01-04-2004, 03:33 PM
Replies: 3
Views: 477
Posted By dannydaville

RE: Last charging question.

Based on an article written by Dave Thacker taken from his web site at www.radicalrc.com Dave writes that you have to put at least 140% in a nicad to fill it up. He considers this the bare minimum. ...
Forum: Batteries & Chargers
12-11-2003, 08:01 AM
Replies: 13
Views: 1,579
Posted By dannydaville

RE: multifunction charger?

Jim,

Could you provide more info on the "Actiator Charger"? Source, etc.?
Forum: Batteries & Chargers
12-07-2003, 09:55 PM
Replies: 13
Views: 1,579
Posted By dannydaville

RE: multifunction charger?

They are 2.5mm co-ax plugs. Radio Shack carries them, usually two in a pack. The center pin is positive so if you make your own adapters make sure the positive lead goes to the center pin.
Forum: Batteries & Chargers
12-05-2003, 10:49 PM
Replies: 13
Views: 1,579
Posted By dannydaville

RE: multifunction charger?

The charger will also charge NiMh battery packs. It is NOT a fast charger but a C/10 charger. I've charged both Ni-cad and NiMh for the past few years on it with no problems.
Forum: Batteries & Chargers
12-05-2003, 06:28 PM
Replies: 13
Views: 1,579
Posted By dannydaville

RE: multifunction charger?

Press the program button and it will start blinking. Then press and hold any of the 6 ports you want programmed. Hold that button until you reach the charge in ma that you want. Mine goes from 1...
Forum: Batteries & Chargers
11-27-2003, 12:17 AM
Replies: 71
Views: 7,120
Posted By dannydaville

RE: <span class=lynnyk

Your explanation has nothing to do with the original thread. Stop the bickering and get on with it. This thread was about ordering a Litco Alfa 4 and nothihng else.
Forum: Batteries & Chargers
11-27-2003, 12:08 AM
Replies: 71
Views: 7,120
Posted By dannydaville

RE: <span class=lynnyk

Please stop this crap. It has nothing to do with the original thread. Moderators where are you? Sfaust and Aerogrqfix knock it off!
Forum: Batteries & Chargers
11-23-2003, 10:23 AM
Replies: 71
Views: 7,120
Posted By dannydaville

RE: <span class=

I agree with Sfaust when he says Litco wants to keep the business small, lean and simple. My father started a business after retirement making gas analyzers of his own design for major corporations...
Forum: Batteries & Chargers
11-22-2003, 11:59 PM
Replies: 71
Views: 7,120
Posted By dannydaville

RE: <span class=lynnyk

You lost in the lottery, eh?
Forum: Batteries & Chargers
11-21-2003, 01:11 PM
Replies: 71
Views: 7,120
Posted By dannydaville

RE: <span class=

9:02 AM EST. I get my Alfa4 in April of '04! I wonder how many emails were sent in the first 2 minutes besides mine. I had to smile when I read Driver9's comment when he likened the the owner of...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.