RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: scattermaster
Showing results 1 to 25 of 142
Search took 0.51 seconds.
Forum: Club 40
10-31-2019, 05:51 PM
Replies: 2
Views: 3,789
Posted By scattermaster

I don't get it. I'm looking on Weather Channel...

I don't get it.
I'm looking on Weather Channel right now. They're calling for no rain, and N 12mph at 9am, N13 mph at 10am till-2pm then it starts dropping back off again.
what gives?
Forum: Control Lines
09-22-2019, 01:06 PM
Replies: 2
Views: 4,837
Posted By scattermaster

Yuvenko Speed Limit design questions

Is anyone familiar with these? Anyone flying them?
I just received 10 of Yuvenko's speed limit airplanes. they look nice, better than I could have done if I had built them...
Anyway, after getting...
Forum: RC Boats General Discussion
06-19-2019, 01:36 PM
Replies: 6
Views: 4,372
Posted By scattermaster

I know this a really old thread but I just got my...

I know this a really old thread but I just got my 1st boat and I'll be looking for a place to run.
It's a Proboat Sonicwake 36.
Are these places still active?
thx,
Jim
Forum: Club 40
03-16-2019, 02:50 PM
Replies: 4
Views: 1,489
Posted By scattermaster

Hey Fred, Good to hear. I haven't been...

Hey Fred,
Good to hear.
I haven't been in the air since the last race. Been workin and playing machinist.
SO,
I'll be there on Friday for a workout. Heck, now I might even go fly a...
Forum: Club 40
02-22-2019, 09:15 AM
Replies: 4
Views: 1,489
Posted By scattermaster

2019 Texas racing?

Hey guys,
I haven't seen or heard from anyone yet and it's getting close to our racing season. Usually Georgetown kicks us off in mid March.
I'd like to know as much in advance as I can so I can...
Forum: Electric Pylon Racing
10-25-2018, 05:38 PM
Replies: 1
Views: 1,524
Posted By scattermaster

I'll be there unless weather gets in the way. ...

I'll be there unless weather gets in the way.
Steve B.
Like usual I'd like to come through Waco and get a workout on Friday before I head up to the Ft. Worth area. Hope to see ya there.
Jim
Forum: Electric Pylon Racing
10-25-2018, 05:30 PM
Replies: 2
Views: 1,536
Posted By scattermaster

I looked and looked and looked for loose magnets...

I looked and looked and looked for loose magnets and I just can't find any. I'm at a loss.
I did learn a couple of interesting things though.
1. Someone told me that the magnetism alone would hold...
Forum: Electric Pylon Racing
10-25-2018, 05:13 PM
Replies: 6
Views: 3,348
Posted By scattermaster

Smile Edit, I WAS gonna say that it might just end up...

Edit,
I WAS gonna say that it might just end up hanging up in my dining room but I think Jerry would rather I kick some tail with it...
http://www.rcuniverse.com/forum/images/icons/icon7.gif
Forum: Electric Pylon Racing
10-19-2018, 05:08 AM
Replies: 2
Views: 1,536
Posted By scattermaster

Rimfire motor mystery?

So,
I've been running the Rimfire motors for the last 3 or 4 years because that's what all the fastest guys are running. Along with the rest of their power set up.
The motors usually run normal...
Forum: Electric Pylon Racing
10-13-2018, 07:58 PM
Replies: 6
Views: 3,348
Posted By scattermaster

yeah, that's who I ordered it from. I'll...

yeah, that's who I ordered it from.
I'll check out the thread...
I really like the way these look.
thx,
Jim
Forum: Electric Pylon Racing
10-13-2018, 05:32 PM
Replies: 6
Views: 3,348
Posted By scattermaster

https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1493/img_2134_cf640f1ee17fe3d1238d1bfc41c934a7f3b93163.jpg

A Mark Ackerman kit. This one really grooves...
sorry about the big...
Forum: Electric Pylon Racing
10-12-2018, 04:28 PM
Replies: 6
Views: 3,348
Posted By scattermaster

Are GR-7 kits available?

Hey guys,
I was on the NMPRA website today in their forum and there was a posting that said someone was selling GR-7 kits.
I sent an email to the attached address but it came back as...
Forum: Electric Pylon Racing
10-07-2018, 05:12 PM
Replies: 2
Views: 1,229
Posted By scattermaster

Thank you Austin! You guys did a great job...

Thank you Austin!
You guys did a great job putting on this race.
At 12 entries I believe it was the best EF1 turnout in Texas this year so far. With that pesky south wind we also had the most...
Forum: Electric Pylon Racing
10-02-2018, 06:47 PM
Replies: 2
Views: 1,229
Posted By scattermaster

It's looking like it's gonna be a wet one but I...

It's looking like it's gonna be a wet one but I plan on being there.
:-)
Forum: Club 40
09-15-2018, 05:08 PM
Replies: 4
Views: 946
Posted By scattermaster

Gary, Big thanks to you and Sarge and all of...

Gary,
Big thanks to you and Sarge and all of the other guys that took time from their day to let us race.
I know it wasn't the biggest turnout but it all worked out and I for one appreciate your...
Forum: Club 40
09-07-2018, 04:09 PM
Replies: 1
Views: 804
Posted By scattermaster

Gary, Not sure about your set up but both of...

Gary,
Not sure about your set up but both of mine needle good and don't go lean in the turns like a lot of them do. (and I don't use the exhaust restriction)
I have the newer engines so I guess...
Forum: Club 40
02-07-2018, 08:48 AM
Replies: 2
Views: 1,361
Posted By scattermaster

Texas pylon racing 2018?

It's almost time to get back at it.
Does anyone have a schedule yet?
Bob, or anyone at Georgetown, are you going to get us started in March?
Jim
Forum: Club 40
09-04-2017, 07:28 AM
Replies: 1
Views: 1,778
Posted By scattermaster

is it safe to assume the field is in good shape? ...

is it safe to assume the field is in good shape?
I just made my travel plans, I'll be there.
Steve B,
I'd like to come through Waco and fly on Friday. I have planes that need test flying and...
Forum: Club 40
04-08-2017, 06:33 PM
Replies: 10
Views: 2,244
Posted By scattermaster

Steve, Big thx to HOTMAC for putting on...

Steve,
Big thx to HOTMAC for putting on another event. You guys did a great job.
It was really windy but we all had a good time.(and I only lost one airplane...)
See ya in Fort Worth
Forum: Club 40
04-06-2017, 06:47 PM
Replies: 10
Views: 2,244
Posted By scattermaster

I'll be there tomorrow. taken the day off... ...

I'll be there tomorrow. taken the day off...
:-)
Forum: Club 40
04-05-2017, 07:14 AM
Replies: 10
Views: 2,244
Posted By scattermaster

I checked my weather app today and it's calling...

I checked my weather app today and it's calling for winds to be 20 gusting to 30.
gonna be real bumpy.
Forum: Club 40
03-28-2017, 10:09 AM
Replies: 15
Views: 1,113
Posted By scattermaster

Scully, Are you coming to Waco? If you...

Scully,
Are you coming to Waco?
If you want, we can hook up and fly at your place. Get back at me.
(all the guys have my email and phone)
Forum: Club 40
03-19-2017, 12:55 PM
Replies: 15
Views: 1,113
Posted By scattermaster

Who's yer daddy! :-) Just gotta figure out...

Who's yer daddy!
:-)
Just gotta figure out how to stay on the outside of the pylons...
See yall at waco
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-26-2017, 07:25 AM
Replies: 19
Views: 3,985
Posted By scattermaster

Hiec HG3XA gyro set up questions

Hi guys,
I installed a HiTec HG3XA stabilizer into my Estrellita EF1 pylon racer and I"m having 2 issues that are not covered in the manual and I need some help.
Gyro location is not per the...
Forum: Multi-rotor Beginner
02-12-2017, 11:04 AM
Replies: 0
Views: 697
Posted By scattermaster

I need some help

I'm new to drones/quads.
I've been flying a Tiny Whoop and a Blade Inductrix 200 using a Fat Shark Attitude V3.
I'm trying to move up to racing drones so I bought a Rise RSX270.
It uses...
Showing results 1 to 25 of 142
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.