RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: CMG
Showing results 1 to 25 of 61
Search took 0.80 seconds.
09-17-2008, 01:27 PM
Replies: 6
Views: 1,095
Posted By CMG

RE: Speed controller choice

what did you think of the 535, how was the low end motor torque?

Mark
09-16-2008, 01:06 PM
Replies: 6
Views: 1,095
Posted By CMG

09-15-2008, 12:40 PM
Replies: 6
Views: 1,095
Posted By CMG

Speed controller choice

Hello,
I need some advice in my choice of replacement speed controller after my current one has finally started to play up.

The one I am currently looking at is a Robbe navy control 535 R. has...
07-22-2006, 10:28 AM
Replies: 3
Views: 947
Posted By CMG

Spektrum radio in the UK

Hello,
I'm planning a trip to England and was woundering if I can take my DX6 Spektrum radio over so I can get some flights in on my Trex.
Forum: T-Rex heli
06-16-2006, 10:03 AM
Replies: 8
Views: 1,067
Posted By CMG

RE: Tail rotor servo

JR Digital 3650
http://www.horizonhobby.com/Products/Default.aspx?ProdID=JRPSZ3650
06-14-2006, 10:51 PM
Replies: 12
Views: 987
Posted By CMG

RE: TRex SE Easier to Fly than the Blade CP?

You are joking, the TREX is so easy to work on its not funny
Have you looked at the cost of repair parts for a CP compaird to a CP?

lets not even ad into the equation of replacing the motors...
Forum: T-Rex heli
06-14-2006, 04:20 PM
Replies: 4
Views: 651
Posted By CMG

RE: hummingbird elite 3d pro

I used to have one along with 2 other buddy's that had one, PIA to work on and just don't fly that well. Inside or out.
A TREX is just so nice to fly. I go to say its like night and day difference...
Forum: T-Rex heli
06-13-2006, 09:21 PM
Replies: 4
Views: 651
Posted By CMG

Forum: T-Rex heli
05-25-2006, 04:59 PM
Replies: 8
Views: 914
Posted By CMG

RE: NEED HELP,PICKING GYRO HEADING HOLD

I have 2 CSM 420's and they are the easiest to setup, bar nun[8D]
I think the in air programing you refer to is the in air trim, I thought it is a recommendation and NOT a requirement, however my 2...
Forum: T-Rex heli
05-25-2006, 04:08 PM
Replies: 10
Views: 4,922
Posted By CMG

RE: ive purchased a SL 420 gyro any good ?

Just follow step by step the instrucions that came with the Gyro, its real simple...:)

just make sure you set up your radio correct by setting the gyro gain channel to 60 for both positions of...
Forum: T-Rex heli
05-13-2006, 10:21 PM
Replies: 4
Views: 990
Posted By CMG

RE: Digital tail servos

JR Z3650 Digital Servo
Forum: T-Rex heli
05-13-2006, 10:19 PM
Replies: 4
Views: 681
Posted By CMG

RE: How much gain are u guys using?

95% with a CSM420E and a JR Z3650 and a ROCK solid tail:D
Forum: T-Rex heli
05-10-2006, 02:59 PM
Replies: 5
Views: 904
Posted By CMG

RE: Trex 450SE - Any assembly "gotchas"?

Yes,
Take ALL the factory installed screws out on EVERYTHING including the head and apply Loctite to them. I had a bad experiance with a factory instaled screw in a ball link departing the from the...
Forum: T-Rex heli
04-26-2006, 06:06 PM
Replies: 10
Views: 4,922
Posted By CMG

RE: ive purchased a SL 420 gyro any good ?

I second that it a real nice Gyro and I Love the setup. The tail on my Rex is rock stable.
Way way better to setup than the dinosaur 401 :D

Mark
Forum: T-Rex heli
04-26-2006, 06:01 PM
Replies: 6
Views: 1,027
Posted By CMG

RE: Took the SE Plunge !!!!

Just a word of warning, remove all the screws fitted by the factors especialy the ball links, and apply LocTite to them all, I had a ball link come lose on my swash plate on its check flight and my...
03-09-2006, 05:44 PM
Replies: 6
Views: 692
Posted By CMG

RE: spektrum radio in a Blade CP

Yes it can be done, I did my own and a Budys at the flying site!
Check out the following sites for more information on how to do it.

http://www.runryder.com/helicopter/t194740p1/

and

...
03-03-2006, 11:40 PM
Replies: 6
Views: 692
Posted By CMG

spektrum radio in a Blade CP

Has anyone modified the 4 in 1 used in the Blade CP just removing the standard 72Mhz receiver and connecting in the spektrum receiver in its place.
If so what was the setup you used in the...
Forum: Glow Engines
03-02-2005, 04:59 PM
Replies: 14
Views: 1,096
Posted By CMG

RE: YS 110 seems to go lean....

the fuel could be foaming, the level and frequency of vibration changes when the plane is in the air.

Check your tank instalation is my recomendation.
Forum: Glow Engines
01-27-2005, 01:55 PM
Replies: 13
Views: 3,499
Posted By CMG

RE: YS engine needs a fuel tank!

Hayes is the ONLY way to go, Never had any problems.
Its the only tank to use, in YS and Non -YS instalations.

use one and you will see why they are so good
Forum: RC Jets
01-16-2005, 07:29 PM
Replies: 53
Views: 10,140
Posted By CMG

RE: 2005 Jet events

Ozark Mountain Jets
8,9,10, 11 September 2005,Sullivan regional Airport, Missouri

Airport closed to full size for event, Public notary along with 3 turbine waver CD's on site for turbine...
Forum: Kit Building
12-15-2004, 06:33 PM
Replies: 152
Views: 25,727
Posted By CMG

RE: Ultra Sport "Lite"

wuhoooooooooooooooooo:D
Now Christmas has come, cannot wait for the kit.

keep us posted as you learn more information, I need to get 1 or 5 of the kits for myself......;)

There is never a...
Forum: Glow Engines
12-13-2004, 09:59 AM
Replies: 20
Views: 1,948
Posted By CMG

RE: need help! Super tigre problems.

An OS "F" plug is a 4stroke plug!

When I used to race ST40's the best plug was a KB1L or an Mc Coy MC9. Also used to run coolpower 15% and had seasons of of over 15,000 RPM.

I would a 2...
12-01-2004, 11:41 PM
Replies: 20
Views: 1,681
Posted By CMG

RE: AMA advertise on TV?

How about this for free advertising of our r/c hobby and what it all about ?
The TV station did an outstanding job what do you think?

Ozark Mountain Jets on NBC
Forum: Kit Building
11-08-2004, 10:48 PM
Replies: 6
Views: 1,077
Posted By CMG

RE: Got pics of retractable GP Ultra Sport 40?

More power the better I say.
I have had an Ultra sport 40 wit and old YS60 2 stroke, I currently have on with a OS91 4 Stroke, with adequate vertical:eek:
No problem with engine fit on either...
Replies: 14
Views: 1,153
Posted By CMG

RE: Modify radio for new Freq in the Amateur band..

Spend the bucks and get you one of these and you should never have a problem.
http://www.spektrumrc.com/ its sold by Horizon Hobby http://www.horizonhobby.com/Explore/Article.aspx?ArticleID=1389
...
Showing results 1 to 25 of 61
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.