RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: 1QwkSport2.5r
Showing results 1 to 4 of 4
Search took 0.01 seconds.
Forum: RC Car Engines
10-14-2018, 08:31 AM
Replies: 8
Views: 1,459
Posted By 1QwkSport2.5r

As for the fuel - what brand/type? If it’s...

As for the fuel - what brand/type? If it’s something like backyard basher or Traxxas fuel, it has way too much oil in it and will cause these kinds of problems. Lower oil fuel usually doesn’t...
Forum: RC Car Engines
10-13-2018, 05:40 PM
Replies: 8
Views: 1,459
Posted By 1QwkSport2.5r

The starter shaft will get glazed over time. ...

The starter shaft will get glazed over time. When the engine is running, that shaft is spinning with the engine constantly within the one-way clutch bearing. The cure for this is to lightly sand...
Forum: RC Car Engines
10-13-2018, 06:32 AM
Replies: 8
Views: 1,459
Posted By 1QwkSport2.5r

Cool! Good luck!

Cool! Good luck!
Forum: RC Car Engines
10-13-2018, 04:25 AM
Replies: 8
Views: 1,459
Posted By 1QwkSport2.5r

It sounds like the idle mixture is too rich and...

It sounds like the idle mixture is too rich and the high speed (main needle) is too lean. I would double check that the idle gap is no larger than 0.7mm and set your high speed needle 1 full turn...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.