RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: mironpopescu1
Showing results 1 to 16 of 16
Search took 0.09 seconds.
08-21-2009, 12:45 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132

nice choice Henrick but you wanted a large plane. Dark colors make it smaller and hard to see. good luck Mike
06-07-2009, 04:45 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132

Hello to all ! The attached picture shows my second C 130 that includes the zero incidence elevator. Study the plan and make changes on parts affected before gluing or CA them. This one is ready for...
03-17-2009, 09:06 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Sorry, sorry and sorry again. Four postings finally got my attention and strenght to answer. I am no better than 3 weeks ago, not because of B C but because of post surgery infections. Yes with S at...
02-26-2009, 07:12 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Got a flight yesteray Feb 25. Winds die down later on the day at measured 8-10 and gusts to 12. Major problem was the rotating direction of the wind so that I can lock on the correct landing vector....
02-20-2009, 06:34 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Thanks Dad and Props4ever. I screwed up a folder containing more picture in which I had a landind picture. I will be flying next Tuesday ( I hope, winds are 15-20 everyday ) and get a bunch of...
02-17-2009, 06:47 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

here is something new : finally got a good day to fly my C 130 Coast Guard scheme some of you had seen it pictured above. Frank the Oltimer made the trip from Sarassota with two friends to see the...
12-18-2008, 07:50 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

If you know that you are going to be below 45 lbs total weigth including fuel a 60 2 cycle will do the job as long as the spec indicates a minimum of 0.9 hp torque. Some brand may do some may not....
12-18-2008, 06:28 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

here are 2 pictures
12-18-2008, 06:24 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Ok Prop4ever here it is. Got at the field by 10 am and took may be 30 min to get the Herk together. Started the engines and with some practice of a cold run 3 guys hold the plane about 45 deg nose...
12-17-2008, 10:59 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Thank you gentelman Mike
12-17-2008, 06:23 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Hi Sam it is a Toyota Siena 2004. Plane fits perfect with the nose in between the seats the nose at my rigth elbow down on the floor and the stab tips almost 1/4 clearance from the lateral walls. The...
12-17-2008, 06:14 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Its Palmer 132 inch span. Mike
12-17-2008, 03:38 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Mine came at 33.4 lbs wing loading at 43.14 ounces per sq ft. Mike
12-08-2008, 09:19 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

I ALSO LOOKED AT ELECTRIC VERSION AND HERE ARE TWO FACTORS TO REMEMBER. 1. TO GET PALMER ON THE AIR FOR ABOUT 3 MINUTES IT TAKES 4 LIPOS OF 5000 MAH EACH COSTING ABOUT $ 450 A PIECE. iF YOU FLY 100...
12-04-2008, 07:38 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Hello Frank, this baby is ready for Monday first fligth. 38 lbs fueled and 4xOS 70 pulling 24 lbs trust on the ground fish scale i feel confident will soar. More after Monday Mike
10-31-2008, 07:37 PM
Replies: 1,915
Views: 385,366
Posted By mironpopescu1

RE: Palmer 132" C-130 Build

Hello Frank, just finish painting my Herk and plan now to have it rolling and debug as necessary till I would decide to push the throtle and squeeze the elevator. I also would like to sell it if I...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.