RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Maj_Overdrive
Showing results 1 to 2 of 2
Search took 0.02 seconds.
Forum: RC Car General Discussions
07-31-2014, 12:35 AM
Replies: 5
Views: 537
Posted By Maj_Overdrive

Sometimes a glue is used for press fit end bells....

Sometimes a glue is used for press fit end bells. Could try a little heat to soften it up
Forum: RC Car General Discussions
07-31-2014, 12:25 AM
Replies: 5
Views: 537
Posted By Maj_Overdrive

The end bell on the wire side is likely just...

The end bell on the wire side is likely just pressed in, can't exactly screw it in with the wires there. Try tapping on the motor shaft (pinion side) and see if the end bell will move. You could also...
Showing results 1 to 2 of 2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.