RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: PilotLight
Showing results 1 to 17 of 17
Search took 0.11 seconds.
Forum: 3D Flying!
09-30-2008, 11:57 AM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Wanted to give you a heads up of a couple pit falls I came across while putting mine together.

1. The measurement for the axle lengths was off. Mine came out nearly too short. Just put the...
Forum: 3D Flying!
08-11-2008, 11:28 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

OK, finally had a chance to do some more research on the harrier 90. I removed the muffler and the prop and the cowling to see if there was some bad fuel tubing causing an air leak. Iā€™m using a...
Forum: 3D Flying!
08-08-2008, 11:16 AM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Had the same problem last Wed night with the motor. Couldn't get it started without flipping the whole plane up-side-down to get the motor upright. Finally, it lit after about 40 minutes of messing...
Forum: 3D Flying!
07-27-2008, 12:07 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Speaking of engine setups, I have an O.S. 91 Fx swinging a 15x4 APC prop. For nearly two years, I would fill the tank, spin the prop by hand a couple of times, then spin it with the starter and plug...
Forum: 3D Flying!
02-18-2008, 04:54 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

I thought the PVC pipe was part of the aiplane. I guess it was just the camera angle as I now see its an airplane stand.
Forum: 3D Flying!
02-18-2008, 02:39 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Looks like you had to "Beef up" the landing gear. I like the pilot figure.[8D]
Forum: 3D Flying!
01-04-2008, 06:52 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

I had a day when the bolts on the canopy would back out, then the fly wires on the tail came loose, then the bolts came loose again, then the motor back fired and spun the nut off the prop. Had to...
Forum: 3D Flying!
01-03-2008, 10:37 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Harrier 90 with an O.S. 91 FX with APC 15x4 prop. Hovers at about 5/8th throttle. Pulls out, not ballistic, but will recover nose up and accelerate. I had to mount the needle valve remotely to get...
Forum: 3D Flying!
10-04-2006, 02:40 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Does it stop when you land? Seems like it would never quit. To me, this is a 60 size plane with the recommendation for a 90 to do 3D. 120 is a little aggressive, but I haven't seen the video yet. ...
Forum: 3D Flying!
01-08-2006, 10:37 AM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Absolutely, Flies like a trainer on low rates.;)
Forum: 3D Flying!
01-06-2006, 09:53 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

What happened to cause the rebuild. Just wondering if it was mechanical, or flying quality of the airplane, or pilot error, etc.

Looks like it should fly great.
Forum: 3D Flying!
01-04-2006, 06:05 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

I am running an OS 91FX in mine. It will do the job. It pulls out of hover nicely and will accelerate straight up. In Waterfalls is where you can see the performace the best. It does take full...
Forum: 3D Flying!
12-15-2005, 06:57 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Fly it and see if you like it. I Gaurantee you will. Then let us know if its too heavy.
Forum: 3D Flying!
12-12-2005, 01:45 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

According to the Manual ( http://www.horizonhobby.com/ProdInfo/Files/SEA3000_manual.pdf ) the cg should be 170-180 mm back from the leading edge.
Forum: 3D Flying!
12-05-2005, 12:15 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

I use Futaba 3004 on everything but the rudder. High torque Hobbico. Do you really feel the increase in performance with Digital Servos?
Forum: 3D Flying!
06-30-2005, 12:14 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Northwing,

I do the same thing with my O.S. 91 FX. Just be careful you don't create too much pressure in the tank. The plug in the tank blew out once and all the fuel went into the cowl and...
Forum: 3D Flying!
05-26-2005, 10:57 PM
Replies: 881
Views: 104,612
Posted By PilotLight

RE: SEAGULL HARRIER 90...WHO'S GOT ONE?

Just flew mine today. Equipped with an O.S. 91fx and a 15x4 prop. I added no weight with the battery installed just aft of the bulkhead at the rear of the canopy and the receiver under the rear of...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.