RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: DieHarder
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 19
Views: 4,659
Posted By DieHarder

ESC is in the back, battery up front, receiver in...

ESC is in the back, battery up front, receiver in front receiver box, BEC is next the ESC in the back as well. If I get a lift kit, I wouldn't go full lift, but instead, go just enough for a little...
Replies: 19
Views: 4,659
Posted By DieHarder

I can't wait to run 2.2s! I'd like to go over...

I can't wait to run 2.2s! I'd like to go over bigger obstacles and have more clearance. I also want to widen it up some. I plan on using either 13mm or 19mm wheel wideners. Junfac has some nice...
Replies: 19
Views: 4,659
Posted By DieHarder

I found out that the set I asked about earlier...

I found out that the set I asked about earlier...
Replies: 19
Views: 4,659
Posted By DieHarder

The dick cepeks look epic! But I can't afford to...

The dick cepeks look epic! But I can't afford to shovel out $120-130 on a set of rims. I still need to buy $60 in tires! I looked at some motoworx, but it's like $100 for their cheapest 2.2 set...
Replies: 19
Views: 4,659
Posted By DieHarder

Zach: I'll do some searching for those... ...

Zach: I'll do some searching for those...

Larry: I crawl alone, so that shouldn't be an issue. I've got one dude I talk to in person other than the LHS owner that is into the hobby. He's an Integy...
Replies: 19
Views: 4,659
Posted By DieHarder

Zach: Are these the High Mass ones you were...

Zach: Are these the High Mass ones you were looking at?...
Replies: 19
Views: 4,659
Posted By DieHarder

I've read that adding axle weights instead of...

I've read that adding axle weights instead of wheel weights is a better route to take. That way you keep the heavy rolling mass to a minimum while still getting the weight where you need it. Just...
Replies: 19
Views: 4,659
Posted By DieHarder

Integy Beadlocks: Are they that bad?

Ok, so I'm looking at getting a set of aluminum beadlocks and mounting RC4WD Mudslingers XL 2.2 on them. They would go on my SCX10 G6. I don't want to spend $120 on a set of RC4WD or Vanquish rims....
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.