RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: COL J
Showing results 1 to 10 of 10
Search took 0.07 seconds.
12-17-2006, 01:38 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Xrossbow,

There are no H/S close by. I deal mostly with Bryan Batch at B&B Hobbies in Spokane.

There are a couple of us who fly off the airport out by the lake. Actually, it is only about...
10-30-2006, 08:28 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Xrossbow,

I live right on Lake Curlew. We have a house on a point so that is where I fly. Otherwise, I fly at the Republic airport which is about 2 mi from me. Haven't been on this fourm much...
08-17-2006, 05:53 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Greg,

Thanks for the info on the switch. It worked perfectly and is a needed safety valve.
08-15-2006, 10:56 AM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Greg,

This sounds neat except I not sure how you wired the on/off switch into the ESC. That would be nice to turn the ESC on/off after you have connected the battery. Would like to see how you...
08-11-2006, 12:07 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

I can't tell any difference in the water left or right. You are right, I should have noticed that. Sometimes with these ARFs you get so tied into to following instructions you just overlook. Haven't...
08-11-2006, 10:32 AM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

I noticed with mine that the rudder does not want to come back to center due the flex in the tube/cable assembly. Where the instructions say to place the last brass clamp is apparently not far enough...
08-07-2006, 06:51 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Well, lets try this again.
08-07-2006, 03:19 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Here are a few pics.
08-07-2006, 03:14 PM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Charley,

Yes, I basically assembled them and put them on per the instructions. I used the Thunder Power 4200 mah pack and shoved forward as far as it would go and the CG came out just fine.
08-07-2006, 10:46 AM
Replies: 395
Views: 77,157
Posted By COL J

RE: E-flite J-3 Cub 25 ARF

Greg,

Very nice and informative review. I have mine completed now. The floats were on backorder for awhile. Have not flown it as yet because my radio is at JR SVC for a check-up and replacement...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.