RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: PeterNzen
Showing results 1 to 25 of 37
Search took 0.66 seconds.
Forum: IMAC
05-09-2006, 09:08 PM
Replies: 19
Views: 2,920
Posted By PeterNzen

RE: Expo for precision flying?

I don't like too much expo for precision flight either. I tend to use 15-25 on all flight controls, and only use IMAC and 3D flight modes.

I setup the ailerons for the correct roll rate at the...
Forum: Team RCU - Don Szczur
02-14-2006, 05:15 AM
Replies: 16
Views: 3,295
Posted By PeterNzen

RE: Romilly Experiences

Wow... amazing story Don!

We are trying to organise a trip to the US nationals in July. So It's great to hear about your international experience.

Thanks for giving us this insight.
Forum: RC Pattern Flying
01-08-2006, 05:17 PM
Replies: 66
Views: 8,154
Posted By PeterNzen

RE: Dual RX Battery & Switch

Yep, same applies with a 4 cell pack.

If you think about 'detecting' a short with a meter before flying, what will the meter show if a cell is shorted?

A shorted cell is the same as simply...
Forum: RC Pattern Flying
01-08-2006, 05:52 AM
Replies: 66
Views: 8,154
Posted By PeterNzen

RE: Dual RX Battery & Switch

It seems to me that the 2 batteries plugged into 2 rx ports should be fine even if a cell shorts. If we say you are using 5 cell packs, then a 5 cell pack with a shorted cell will appear as a 4 cell...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-29-2005, 08:09 AM
Replies: 10
Views: 1,159
Posted By PeterNzen

RE: Which servos center really well?

Most small digital servos would give you the accuracy you're looking for. I'm not familiar with Futaba servos, but I have used the JR DS9411s and JR DS3421s they are both very accurate and powerful....
Forum: RC Pattern Flying
09-24-2005, 04:26 AM
Replies: 21
Views: 2,375
Posted By PeterNzen

RE: cyclone build

Hi Chris, looking good. Just remember... every gram counts :-). Now if I can just get my next one up to that stage I'd be right. Hope you guys are going well.
Forum: Glow Engines
09-01-2005, 08:00 PM
Replies: 11
Views: 873
Posted By PeterNzen

RE: OS FI experiences

Well, I have run one for several flying sessions and it was going well by the end!

Initial start-up on the bench was good, but as usual it was a different beast once in the air. You really need...
Forum: JR Radio & Spektrum Radios
07-13-2005, 12:35 AM
Replies: 8
Views: 1,081
Posted By PeterNzen

RE: Is There a Future PCM10X?

The ability to use the dual rate switches for something other than dual rates would be good. Also, allowing a switch to be assigned to the timer. And some more free mixers or allowing channel...
Forum: RC Pattern Flying
06-29-2005, 08:43 PM
Replies: 5
Views: 921
Posted By PeterNzen

RE: Header tank?? Good?? Bad?? should I, and how to do it

We tried putting the tank on the CG and using a header tank on a Pilot/EZ Seduction. This was with a non-pumped OS 70 and it did not work well at all. The header tank just adds greater restriction....
Forum: Classic RC Pattern Flying
06-01-2005, 04:19 AM
Replies: 31
Views: 9,677
Posted By PeterNzen

RE: Plans from the very last part of the .60 2-stroke period

Hey Erik,

What about a Conquest 4? We had one that was modernised using an OS 90 4 stroke and fixed gear. I've still got the plan... but like most of the designs from that period? it has a...
Forum: RC Pattern Flying
04-06-2005, 08:28 AM
Replies: 4
Views: 540
Posted By PeterNzen

RE: YS 1.10 rebuild

Hi Steve,

I've replaced the regulator seals on our 140L and just recently 140DZ. These seem to make the most difference. I just ordeered the standard YS diaphragms and regulator gaskets for each...
Forum: JR Radio & Spektrum Radios
03-13-2005, 02:52 AM
Replies: 2
Views: 465
Posted By PeterNzen

RE: DS-9411 Unavailable?

Ok, Thanks Danny.

I may have to order them from you if I cannot get them locally.
Forum: JR Radio & Spektrum Radios
03-10-2005, 08:52 PM
Replies: 2
Views: 465
Posted By PeterNzen

DS-9411 Unavailable?

Hi Danny,

I have been in discussions with the Australian JR distributor over the last week regarding unavailability of the DS-9411.

They claim that Horizon / JR will not supply them with...
Forum: RC Pattern Flying
03-03-2005, 07:01 PM
Replies: 30
Views: 3,453
Posted By PeterNzen

RE: Fliton Infinity90 Build

Hi Ron,

Thanks for the info. I must say, at under 7lb the YS 110 will be awesome!
Forum: RC Pattern Flying
03-03-2005, 05:22 AM
Replies: 30
Views: 3,453
Posted By PeterNzen

RE: Fliton Infinity90 Build

Hi Ron,

Glad to here that the plane went well. Are you still using the Saito, or did you go the YS route? We aren't really interested in replacing the OS 91 pump, since it runs well. I don't...
Forum: RC Pattern Flying
02-26-2005, 06:02 AM
Replies: 6
Views: 564
Posted By PeterNzen

RE: os70 prop size?

I've gotta agree with the APC 13*7. It looks really narrow compared to the normal pattern props, but seems to work well. I think the 12*6 would be abit small, so maybe go even bigger if you want to...
Forum: RC Pattern Flying
02-21-2005, 05:38 PM
Replies: 14
Views: 1,627
Posted By PeterNzen

RE: Wheel pants

I would have to agree - mainly for looks. But how much better does the plane look with them!

They make the undercarriage look like a part of the plane, not just tacked on as an after thought. We...
Forum: RC Pattern Flying
02-20-2005, 05:59 AM
Replies: 30
Views: 3,453
Posted By PeterNzen

RE: Fliton Infinity90 Build

Hi Ron,

Wow - at 6lb 4oz it should be great! This seems far lighter than any other 90 size plane around - perhaps it's a little smaller than the others? I see this as an advantage, since you...
Forum: RC Pattern Flying
02-18-2005, 06:56 PM
Replies: 30
Views: 3,453
Posted By PeterNzen

RE: Fliton Infinity90 Build

Hi Ron,

Looks great! I will be interested to see if the Saito is powerful enough - I hope it is, because we have an OS 91 that we are looking for a home for....
Forum: RC Pattern Flying
02-13-2005, 04:44 AM
Replies: 9
Views: 1,138
Posted By PeterNzen

RE: Glow Plug Setup for starting

I use a home made one, just a 3Ah NiCd in series with an ammeter to the glow plug. The latest one uses 2 completely separate 1.2v cells, with a 3 position switch to select which cell to use. ie. Batt...
Forum: RC Pattern Flying
02-07-2005, 09:01 PM
Replies: 18
Views: 2,680
Posted By PeterNzen

RE: New Cyclone 2m - first flight

Steve,

Looks great!

I've also found that they need very little trimming. Great to see some more NSW guys getting involved - hope to see you at some comps soon.
Forum: RC Pattern Flying
10-12-2004, 08:54 PM
Replies: 11
Views: 1,585
Posted By PeterNzen

RE: Matt Fritz.. Suxess Foamy Biplane pictures

Hey Ned,

Really like the plane. Any chance of sending over a set of plans?

I've been thinking of getting a foamy for a while - and this looks great!
Forum: RC Pattern Flying
06-23-2004, 08:32 PM
Replies: 14
Views: 1,217
Posted By PeterNzen

RE: Revolution Pro

ok... Hope to see you around soon.
Forum: RC Pattern Flying
06-23-2004, 01:34 AM
Replies: 14
Views: 1,217
Posted By PeterNzen

RE: Revolution Pro

Hi Buzz,

Nice work. I've seen Rob's fly, and it looked really good - looks like we'll have to watch out for you in the comp scene from now on... ;)
Forum: RC Pattern Flying
05-30-2004, 10:16 PM
Replies: 13
Views: 1,055
Posted By PeterNzen

RE: YS 140L broken conrod

Ok, thanks. I'll add it to my list of things to try.
Showing results 1 to 25 of 37
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.