First Glass Boat
#127
Thread Starter
Join Date: Jan 2007
Location: Perth, AUSTRALIA
Posts: 786
Likes: 0
Received 0 Likes
on
0 Posts
RE: First Glass Boat
Just house gloss for the paint in the inside, did the woodies the same way and no peeling so did this the same way, yea will paint that suport once everything is lined up. Also might do a gps bracket just behind, found this on e-bay and sent him a e-mail about speed, how high and does it record the highest speed.
http://cgi.ebay.com.au/Globalsat-GD-...item4a9d679891
http://cgi.ebay.com.au/Globalsat-GD-...item4a9d679891
#129
Senior Member
Join Date: Feb 2009
Location: perth W A, AUSTRALIA
Posts: 215
Likes: 0
Received 0 Likes
on
0 Posts
RE: First Glass Boat
ORIGINAL: STEVE MARSHALL
A bit of buffing and polishing and it came up real nice, far from perfect but looks nice.
A bit of buffing and polishing and it came up real nice, far from perfect but looks nice.
that came up good steve. time to start putting it back together,
so mate whats the next project , . once this is finished...
#136
Thread Starter
Join Date: Jan 2007
Location: Perth, AUSTRALIA
Posts: 786
Likes: 0
Received 0 Likes
on
0 Posts
RE: First Glass Boat
LOL well done Mart, the clone is going into it first, got a good deal on the evo and qd pipe. Will see how fast i can get it going with the clone first and then drop the evo into it and see what that can do. I hope to set the boat up for both motors.