My homemade Throttle Sleeve works !!
06-22-2004, 03:35 PM
#1
Thread Starter
My homemade Throttle Sleeve works !!
Well, It may be called "the caveman sleeve" 
, because it´s made from copper tubing and very rough construction, no lathe, but fits OK and works fine, really helps me to control my TD. I used a cylinder with SPI, but the engine ran OK, next time I´ll try a non SPI cylinder and a Babe bee head. Thanks for the attention, any helping comments will be appreciated. Regards.
Claudio
, because it´s made from copper tubing and very rough construction, no lathe, but fits OK and works fine, really helps me to control my TD. I used a cylinder with SPI, but the engine ran OK, next time I´ll try a non SPI cylinder and a Babe bee head. Thanks for the attention, any helping comments will be appreciated. Regards.Claudio
