RCU Forums - View Single Post - Robart Hinge Replacement - Getting the old out?
Thread: Robart Hinge Replacement - Getting the old out?
View Single Post
Old 09-20-2010 | 09:08 AM
  #5  
rcfan450
Senior Member
 
Joined: Dec 2006
Posts: 476
Likes: 0
Received 0 Likes on 0 Posts
From: Heber, UT
Default RE: Robart Hinge Replacement - Getting the old out?
The slack is within the hinge point, not the glued part of the hinge within the wing. So just pulling on it would rip the wood out of the wing I'm afraid. I see what you are saying though, that would work if the hinge was slipping within the elevator.
rcfan450 is offline  
Reply Like