RCU Forums - View Single Post - tightening prop
Thread
:
tightening prop
View Single Post
10-13-2010, 07:19 PM
#
3
hugger-4641
My Feedback: (
6
)
Join Date: Oct 2008
Location: McKenzie, TN
Posts: 1,886
Likes: 3
Received 0 Likes on 0 Posts
RE: tightening prop
If they are M4 they are 1 1/2 to 2 ft/lbs, M5 about 4 ft/lbs . You will not easily find a ft/lb torque wrench that goes that low, so you would need an in/lb torque wrench. 1 ft lb equals 12 in lb.
Reply
Like
hugger-4641
View Public Profile
Send a private message to hugger-4641
Find More Posts by hugger-4641
View iTrader Profile