Wingwarper
Thanks for catching the omission. I added the ".com"but it still will not accept the two dashes between the "=" and the "N". Just type it into your browser correctly.

The servos I am using are 39 oz/in torque standardfor Throttle and Rudder and 75 oz/in torque heavy duty for the Wing Warping. The Elevator warping if by the Control lines and a hand made three piece bellcrank. The Wing warp servo is below the bellcrank. I had to move it to the rear about two inches to getthe cables exiting the body in the scale position.
See picture.
Clancy