RCU Forums - View Single Post - the reason to install a kill switch
View Single Post
Old 11-10-2010 | 06:56 PM
  #5  
STUKA BARRY
 
Joined: Dec 2001
Posts: 1,946
Likes: 0
Received 0 Likes on 0 Posts
From: Summerfield, NC
Default RE: the reason to install a kill switch


ORIGINAL: spaceworm


ORIGINAL: summerwind

had forgotten about this til i recently stepped into gas........the airplane was tough to land as the idle changed drastically........the ending tells the whole story.
the member is a great guy, so no pun intended to him, but it's reality that makes one realize why a kill switch needs to be installed.

enjoy

http://www.youtube.com/watch?v=krQ2w...layer_embedded

What is that expression that defines an action that is repeated over and over expecting a different result even though the conditions have not changed? Seems that flying a pattern until the gas ran out and then landing dead stick would have been a better approach.

Sincerely, Richard
I think a properly tuned engine prior to take-off would've prevented that mishap. I'm very jealous of that mile long runway. Some modelers have all the luck.