ORIGINAL: cummins driver
Is 3.0v per cell too low on the cutoff? My ESC is set for that default and Im ordering the card this week, but will it be fine as long as i charge the batteries back up right away, or should I keep an eye on the voltage and pull them out around 3.4v per cell?
Eric
3.0 IMO is too low, its too close to dipping below 3V which alot of chargers will not charge, from what I hear.
3.2V is recommended I just do 3.4 as a safety barrier. Its also around that time performance starts to degrade anyways.
Think I have my MM set for 3.6V