Istarted using the battshare when Iwas flying 2 x 2600 TBM 7.4 Lions for rx power. Landed Bobcat, opened hatch and everything orange was blinking

ONe of the Lions had dropped a cell in flight and at some point the rx did a quick reboot (glad Ihad the revision) - anyways - everyone said use a battshare to isolate in case of dropping a cell again - so Idid. When Iswitched to 123's Icarried over the battshares and dropped the regs for the new install - agree that probably fine to go without battshare but already had them and they saved me once with the Lion cell drop so.........

You can see my data logger next time Dan, when Ipower up after a full charge on the 123's, the data logger never says higher than 6.5 on the 16, 6.4 on the bobcat.
You're not going to have an overvolt problem trust me, if you do you can kick me in the nuts