RCU Forums - View Single Post - HK 600 clone
Thread: HK 600 clone
View Single Post
Old 11-30-2010 | 05:06 PM
  #5  
RC RedHots's Avatar
RC RedHots
Senior Member
 
Joined: Oct 2009
Posts: 112
Likes: 0
Received 0 Likes on 0 Posts
From: Siler City , NC
Default RE: HK 600 clone

<p style="margin-bottom: 0in">I put my HK 600 in the air a week or so back it was flying like a dream!</p><p style="margin-bottom: 0in">I did a few loops, almost perfect did a few flips almost perfect!</p><p style="margin-bottom: 0in">Then my 5 minute timer went off so I was landing and then the lipo alarm went off Oh well I wasn't high enough for a auto landing or did I have enough experience!</p><p style="margin-bottom: 0in">Oh yes nice hard drop, servo, landing gear, motor shaft, rod end. (didn't take it out of throttle hold).</p><p style="margin-bottom: 0in">All took place in about 3 seconds!</p><p style="margin-bottom: 0in">But it was flying like a dream!</p><p style="margin-bottom: 0in">Bottom line in all the excitement grabbed the wrong batter pack! 3300 ma 30c.</p><p style="margin-bottom: 0in">Didn't know about the battery pack until I took it in the house and seen the 5000 pack on the table!</p><p style="margin-bottom: 0in">And that was the answer why the lipo alarm was going off after only 5 minutes.</p><p style="margin-bottom: 0in">And yes I know the difference from one to the other. (do for sure now)</p><p style="margin-bottom: 0in">Just my 2 cents for the day.</p><p style="margin-bottom: 0in">
</p><p style="margin-bottom: 0in">RCREDHOTS</p>