RCU Forums - View Single Post - Anyone working on a harrier?
Thread: Anyone working on a harrier?
View Single Post
Old 12-19-2002 | 04:08 PM
  #24  
alleycat
Junior Member
 
Joined: Jan 2002
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
From: LA, CA
Default harrier
Will the rear nozzles flow at higher a rate than the front like the full size and if so how would you control the instability problem before and after the CG?
alleycat is offline  
Reply Like