RCU Forums - View Single Post - Making Molds of Classic Pattern Plane Fuselages & Parts to Keep them Alive for all of us to Enjoy!
Thread: Making Molds of Classic Pattern Plane Fuselages & Parts to Keep them Alive for all of us to Enjoy!
View Single Post
Old 01-19-2011 | 02:20 PM
  #77  
frequent flyer's Avatar
frequent flyer
My Feedback: (6)
 
Joined: Feb 2003
Posts: 1,485
Likes: 0
Received 5 Likes on 5 Posts
From: Grand Junction, Colorado
Default RE: Making Molds of Classic Pattern Plane Fuselages & Parts to Keep them Alive for all of us to Enjoy!
David
You bring up a good point about the retracts. I guess if I did the plug in wings design one would be limited to air or electric retracts. Mechanical may be a little tough to connect linkage with a two piece wing.... Do you think that most people would be going the route of Air or Electric?
frequent flyer is offline  
Reply Like