RCU Forums - View Single Post - Prop reamer for BME 44
Thread: Prop reamer for BME 44
View Single Post
Old 04-11-2002 | 08:07 PM
  #1  
the crow
Member
My Feedback: (1)
 
Joined: Dec 2001
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
From: Temecula, CA
Default Prop reamer for BME 44
How do you enlarge the hole on a prop for the BME 44 engine. The shaft has a sleeve where the prop will go. The reamer that I have could only enlarge it to clear the shaft but not the sleeve.
What do you guys use?
I measured the sleeve and it's about 7/16 (0.44 in)
the crow is offline  
Reply Like