RCU Forums - View Single Post - tuned straight pipe for Ryobi conversions
Thread: tuned straight pipe for Ryobi conversions
View Single Post
Old 02-06-2011 | 04:49 AM
  #2  
pe reivers
Senior Member
 
Joined: Jan 2002
Posts: 6,571
Likes: 0
Received 5 Likes on 5 Posts
From: Arcen, , NETHERLANDS
Default RE: tuned straight pipe for Ryobi conversions
An open pipe should be short like about 4 - 6" !
Too long, and the engine will loose all torque at higher rpm. Longer pipes need to be plugged at the end and have a small exit hole added.
pe reivers is offline  
Reply Like