RCU Forums - View Single Post - Would this servo be a direct replace for a sterring
Thread: Would this servo be a direct replace for a sterring
View Single Post
Old 02-26-2011 | 12:33 PM
  #6  
SyCo_VeNoM's Avatar
SyCo_VeNoM
 
Joined: Jul 2007
Posts: 12,988
Likes: 0
Received 44 Likes on 41 Posts
From: North West Indiana
Default RE: Would this servo be a direct replace for a sterring
I'd just go the 645MG for the same cash if it was me, but if you want that one its upto you.
I only got experience with the 645 so I can't comment on the 635(also never heard of anyone say anything positive or negative about it)
SyCo_VeNoM is offline  
Reply Like