Ok guys, based on PM that I got from Atam, he made a CDi from a French site and is for a Suzuki engine, says that it has 3 tables of advance curves and has real hard time to optimize it. Now with Ignition control soft from here will be ideal for him totry to find the best curve by creating his own.He made the timing board ( but I do not know if is the old or new timing board, did not mentioned that) and has trouble comunicating with the programer to get it in program mode. Says that is geting in program mode if he shorts the TX-RX on the PIC, if he works the SW from the CDI schematic does not work. He is asking if is a HEX issue.

This is all I got so far, I do not know much about this and I can not assist...all I can do....translate.


Adrian