what's interresting is that when i get slow over the runway, my right wing drops. that's the same direction it snaop rolls in when i give it elevator. so here's the big problem. our runway is short, and we are on top of a hill so there is always wind going from left-right. I can't do that sharp of a right-left lading approach because my plane snap rolls. you see, my splane stalls at a high speed. that means about 45 mph. then, i have to make that sharp turn into the wind. the plane snaps so badly i can't do that. so, i have to land at 45 mph and stop in 200 feet assuming i manage to touch down at the end of the runway. it is more like halfway down. so, it is very difficult to fly this plane in the wind, so i fly a lot at the basin. as soon as i come up with the money however, i am getting that 65 inch extra with the rediculously large control surfaces. this one is designed for 3d, but is a stunt plane similar in design to my own. so it will fly about the same with the only real differences being that i will have a lot more control authority especially at low speeds, as a wing loading that is about 10 oz sq/ft lighter than my own, is a mid-wing, and is a 3d plane. also, my plane is of niticably low quality and mega-cheap covering. it looks awsome, don't let me fool you, but that polycote ecs stuff is just cheap as can be. i managed to put my big-toe through it when i was replacing the ailerons. this stuff is crap.