RCU Forums - View Single Post - Using Mic servo for St. servo
Thread: Using Mic servo for St. servo
View Single Post
Old 11-01-2011 | 04:44 PM
  #7  
karolh
 
Joined: May 2002
Posts: 6,852
Received 33 Likes on 32 Posts
From: Mandeville, JAMAICA
Default RE: Using Mic servo for St. servo
Torque rating should not be the only consideration here, as one should also take in to account the robustness required in the servo for the type model or application it is going to be used in.

Karol
karolh is offline  
Reply Like