RCU Forums - View Single Post - Aeroworks Quality
View Single Post
Old 01-31-2012 | 05:07 PM
  #47  
speedracerntrixie's Avatar
speedracerntrixie
My Feedback: (29)
 
Joined: Jun 2010
Posts: 9,709
Received 204 Likes on 175 Posts
From: Happy Valley, Oregon
Default RE: Aeroworks Quality


ORIGINAL: Hill202

The maiden was successful. I have to say its a great flying plane. The DLE 55 was plenty of power for it.<span style="color: rgb(255, 0, 0);"> I think I need to move the CG forward some as it was a little too pitchy for me.
</span>
Its a keeper, so if you're on the fence about an AW, I'd say get one and look it over real good as you're putting it together.



How much elevator throw and expo are you running? Did you have to put in any down trim? Up trim? It may just be a matter of reducing throw and/or increasing expo. I would have set it up for the test hop with 15 degrees elevator travel and 30-35% expo.